INTRODUCTION

The ST62T42B and ST62E42B devices are low cost members of the ST62xx 8-bit HCMOS family of microcontrollers, which are targeted at low to medium complexity applications. All ST62xx devices are based on a building block approach: a common core is surrounded by a number of on-chip peripherals.

The ST62E42B is the erasable EPROM version of the ST62T42B device, which may be used to emulate the ST62T42B device, as well as the respective ST6242B ROM devices.

■ 3.0 to 6.0V Supply Operating Range

■ 8 MHz Maximum Clock Frequency

■ -40 to +85°C Operating Temperature Range

■ Run, Wait and Stop Modes

■ 5 Interrupt Vectors

■ Look-up Table capability in Program Memory

■ Data Storage in Program Memory: User selectable size

■ Data RAM: 192 bytes

■ Data EEPROM: 128 bytes

■ User Programmable Options

■ 18 I/O pins, fully programmable as:

– Input with pull-up resistor

– Input without pull-up resistor

– Input with interrupt generation

– Open-drain or push-pull output

– Analog Input

– LCD segments (8 combiport lines)

■ 4 I/O lines can sink up to 20mA to drive LEDs or TRIACs directly

■ Two 8-bit Timer/Counter with 7-bit programmable prescaler

■ Digital Watchdog

■ 8-bit A/D Converter with 6 analog inputs

■ 8-bit Synchronous Peripheral Interface (SPI)

■ LCD driver with 40 segment outputs, 4 backplane outputs and selectable multiplexing ratio.

■ On-chip Clockoscillator can be driven by Quartz Crystal or Ceramic resonator

■ One external Non-Maskable Interrupt

■ ST6242-EMU2 Emulation and Development System (connects to an MS-DOS PC via a parallel port).