Features

• AEC-Q100 qualified

• Full ISO26262 compliant, ASIL-D systems ready

• VDH motor supply voltage range from 4.5 V to 75 V for working in single

(12 V systems), double (24 V systems) and 48 V battery applications

• 3.3 V internal supply voltage generated from 5 V on VDD pin

• Digital I/O compatible to 3.3 V/5 V logics

• 6 separate N-channel FET pre-drivers:

– dedicated source connection to each FET

– the device can withstand -14 V to 95 V on motor connection pins

– 0% to 100% duty cycle operation support

– dedicated PWM input pin for each gate driver

• 3 differential high accuracy current monitors for ground referred current

measurements:

– ADC/DAC architecture

– SPI adjustable Gain Factor and Output Offset

– built-in error calibration

– the device can withstand -14 V to 6 V on input sensing pins

– SPI readable current measurement

– 0 to 4.6 V DAC output dynamic range

• 3 real time phase voltage monitor channels:

– SPI programmable phase voltage feedback;

– SPI readable phase duty cycle measurement;

• 32-bit - 10 MHz SPI interface with 5-bit CRC and 1bit frame counter for internal

setting, self-test and full diagnostics

• Protection and diagnostic:

– SPI programmable VDS diagnostic and protection in on-state

– SPI programmable Dead Time protection

– SPI programmable Shoot-through diagnostic and protection

– Open load, short to GND and short to battery diagnostic in off-state

– Over-temperature diagnostic and protection with SPI programmable

warning flag

– SPI readable Tj measurement

– Ground loss diagnostic

– System clock monitoring

– Power supply pins VDD, VDH, VBP over-voltage and under-voltage

diagnostic

– FET driver supply VPRE and VCP under-voltage and over-voltage

diagnostic

– SPI Window Watchdog

– Fault status flag output