PRODUCT DESCRIPTION

SST’s ATA-Disk Chip (ADC) is a low cost, high performance, embedded flash memory data storage system. This product is well suited for solid state mass storage applications offering new and expanded functionality while enabling cost effective designs.

FEATURES:

• ATA/IDE standard interface

– 512 Bytes per sector

– ATA command set compatible

– Support Data Transfer Speed up to PIO Mode-4

• 8, 16, 24, 32, 48, 64, 96, 128, and 192 MByte capacities

• 600 mil 32-pin DIP package

• Single Voltage Read and Write Operation

– 5.0V-only for SST58SDxxx

– 3.3V-only for SST58LDxxx

• Supports 5.0-Volt or 3.3-Volt Read and Write

– 4.5-5.5V or 3.135-3.465V for Commercial

• Low Power Consumption

– Active mode: 35 mA/55 mA (3.3V/5.0V)(typical)

– Sleep mode: 100 µA/150 µA (3.3V/5.0V)(typical)

• Extended Data Protection and Security

– WP# pin for Data Protection

– Factory-Programmed, 20-Byte Unique ID number

• Sustained Write Performance

– Up to 1.4 MB/sec (host to flash)

• Controller Overhead Command to DRQ

– Less than 0.5 ms

• Zero Power Data Retention

– Batteries not required for data storage

• Start Up Time

– Sleep to read: 200 ns (typical)

– Sleep to write: 200 ns (typical)

– Power-on to Ready:200 ms (typical)

• Support for Commercial Temperature Range

– 0°C to +70°C for Operating Commercial

– -50°C to +100°C for non-Operating (storage)

• Extremely Rugged and Reliable

– Built-in ECC support corrects 3 Bytes of error per 512 Byte sector

• Intelligent ATA/IDE Controller

– Built-in microcontroller with intelligent firmware

– Built-in Embedded Flash File System

• Power Management Unit

– Immediate disabling of unused circuitry 8MB / 16MB / 24MB / 32MB / 48MB / 64MB / 96MB / 128MB / 192MB