■ GENERAL DESCRIPTION

The MBM29BS/BT32LF is a 32M bit, 1.8 Volt-only, Burst mode and dual operation Flash memory organized as 2M words of 16 bits each. The device offered in a 60-ball FBGA package. This device is designed to be programmed in-system with the standard system 1.8V VCC supply.

■ FEATURES

• 0.17 µm process technology

• Single 1.8 volt read, program and erase (1.65 V to 1.95 V)

• Simultaneous Read/Write operation (Dual Bank)

• All Sectors Being Protected Upon Power-up

The device aims for high-speed read of stored codes, thus to fully prevent it from much anticipated wrong

operational procedures, programming and erasure, it adopts All-Sectors Lock for ultimate all sector protection

by default upon power-up.

• FlexBankTM *1

Bank A: 8M bit (8K words × 4 and 32K words × 15)

Bank B: 8M bit (32K words × 16)

Bank C: 8M bit (32K words × 16)

Bank D: 8M bit (8K words × 4 and 32K words × 15)

• Enhanced I/OTM *2 (VCCQ) Feature

Input/ Output voltage generated on the device is determined based on the VI/O level

(MBM29BS32LF: 1.8V VCCQ and MBM29BT32LF: 3.0V VCCQ)

• High Performance Burst frequency reach at 54MHz

Burst access times of 13.5 ns @ 30 pF at industrial temperature range

Asynchronous random access times of 70 ns (at 30 pF)

Synchronous latency of 106 ns with 1.8 V VCCQ, and 106.5 ns with 3.0 V VCCQ (at 30 pF)

• Programmable Burst Read Interface

Linear Burst: 8, 16, and 32 words with wrap-around

• Compatible with JEDEC-standard commands

Uses same software commands as E2PROMs

• Minimum 100,000 program/erase cycles

• Sector Erase Architecture

Eight 8K words, sixty-two 32K words sectors.

Any combination of sectors can be concurrently erased. Also supports full chip erase.

• Write Protect Pin (WP)

At VIL, allows protection of “outermost” 2 × 8K words on low end of boot sectors(SA0 and SA1), regardless of

sector protection/unprotection status

• Accelerate Pin (ACC)

At VACC, increases program performance.

At VIL, hardware protect method to lock all sectors.

• Embedded EraseTM *2 Algorithms

Automatically preprograms and erases the chip or any sector

• Embedded ProgramTM *2 Algorithms

Automatically writes and verifies data at specified address

• Data Polling and Toggle Bit feature for detection of program or erase cycle completion

• Automatic sleep mode

When address remain stable, the device automatically switches itself to low power mode

• Erase Suspend/Resume

Suspends the erase operation to allow a read data and/or program in another sector within the same device

• In accordance with CFI (Common Flash Interface)

• Hardware reset pin (RESET)

Hardware method to reset the device for reading array data

To avoid initiation of a write cycle during Vcc power-up/down, Reset must be VIL for defined time.

• Protection

Software command sector locking

WP protects the outermost two boot sectors(SA0 and SA1)

ACC protects all sector at VIL. Should be at VIH for all other conditions.

• CMOS compatible inputs, CMOS compatible outputs