Features

On/Off & Volume Control

Turns the beltpack power on and controls headset volume.

Wireless Talk Around (WTA)

When pressed, the user’s audio is disconnected from

the wired intercom, auxiliary input/output and the base

station’s local headset. Other beltpack users, on that

audio channel, can hear the user as normal.

Stage Announce

When pressed, the user’s audio is routed to the SA (Stage

Announce) connector on the back of the base station. The user

also loses their sidetone as an indication that stage

announce is activated. The other wireless beltpacks and wired users

do not hear the user’s audio. The button is

nonlatching and activates the nearby red LED.

Audio Channel Select Button

Allows user to select either audio channel A or B.

Bat/Overmod Light (BAT/OM)

Light flashes once when unit is turned on if the battery is good. If

the light stays on, battery is low. If the light does not flash, battery

is dead. A normal microphone gain setting causes the LED to flash

at the beginning of most words at normal speech levels. If the gain

is too high, the LED is red during the complete word at normal

speech levels.

Talk Light

LED is on when the talk button, SA or WTA is active.

Talk Button

The TALK LED, turns red when enabled. A quick press and release

latches the talk function, unless latching has been disabled. Holding

the button for over half a second causes the audio path to be

enabled only for as long as the button is held. If the talk function is

latched on, pressing the talk button again turns it off.