5.5V, 2A Low Loss Power Distribution Switch

文件：1.043099 Mbytes Page：10 Pages

5.5V、2A 低损耗配电开关

SY6280/ SY6280A is ultra-low RDS(ON) switch with programmable current limit to protect the power source from over current and short circuit conditions. They incorporate over temperature protection and reverse blocking functions. SY6280 automatically discharges the output capacitors during shutdown. • 输入电压：2.4V 至 5.5V\n• 2A 负载电流能力\n• 可编程限流阈值\n• 使能极性：高电平有效\n• 过温保护\n• 反向阻断（无体二极管）\n• 关断状态时，输出可强制高于输入\n• 紧凑型封装： SOT23-5;

Low Loss Power Distribution Switch

The SY6280 develops ultra-low Rds(on) switch with programmable current limiting to protect the power source from over current and short circuit conditions. It integrates the over temperature protection and discharges the output capacitor during the shutdown. Incase the output is pulled higher than t • Distribution voltages: 2.4V to 5.5V\r\n• Programmable current limit\r\n• Enable polarity: active high\r\n• Over temperature shutdown and automatic retry\r\n• Reverse blocking (no body diode)\r\n• At shutdown, OUT can be forced higher than IN\r\n• Automatic output discharge at shutdown\r\n• Compact;

具有可编程电流限制的低损耗配电开关

• 输入电压：2.5V 至 5.5V\n• 极低的电源路径电阻：65mΩ（典型值）\n• 可调限流阈值：100mA 至2.5A\n• 热关断，自动重试\n• 反向阻断（无体二极管）\n• 输出电容自动放电\n• 内置软启动\n• 符合 RoHS 标准且无卤素\n• 紧凑型封装：SOT23-5;

5.5V, 2A Low Loss Power Distribution Switch

文件：1.043099 Mbytes Page：10 Pages

5.5V, 2A Low Loss Power Distribution Switch

文件：1.043099 Mbytes Page：10 Pages

5.5V, 2A Low Loss Power Distribution Switch

文件：1.043099 Mbytes Page：10 Pages

Dual Laser Driver with APC Amp

General Description The EL6280C is a combination read + 3 write level laser driver and IV amplifier, with an extra read + oscillator ROM channel for use in dual-laser ‘Combo’ drivers. A separate (amplitude and frequency) oscillator modulates the selected output for laser noise reduction during re

THREE CHANNELS MULTIPOWER DRIVER SYSTEM

DESCRIPTION The L6280 is a multipower driver system for motor and solenoid control applicatios that connects directly to a microprocessor bus. Realized in Multipower BCD technology -- which combines isolated DMOS transistors, CMOS & bipolar circuits on the same chip -- it integrates two 1A mo

DOUBLE HETEROJUNCTION SUNLIGHT VIEWABLE DISPLAYS

DOUBLE HETEROJUNCTION AIGaAs RED SUNLIGHT VIEWABLE DISPLAYS

REAL TIME EMULATION DEVELOPMENT TOOLS FOR ST6 MCU FAMILY

GENERAL DESCRIPTION The ST6 Real Time Development System is an advanced hardware development system designed and configured to provide comprehensive support for the ST6 family of MCUs. HARDWARE FEATURES ■ Supports ST62 and ST63 family ■ Real time emulation ■ 32 KBytes of emulation memory ■ B

DOUBLE HETEROJUNCTION AIGAAS RED SUNLIGHT VIEWABLE DISPLAYS

文件：405.92 Kbytes Page：5 Pages