SNx4LVC541A Octal Buffers/Drivers With 3-State Outputs

1 Features 1• Operate From 1.65 V to 3.6 V • Inputs Accept Voltages to 5.5 V • Max tpd of 5.1 ns at 3.3 V • Typical VOLP (Output Ground Bounce) 2 V at VCC = 3.3 V, TA = 25°C • Support Mixed-Mode Signal Operation on A

Octal buffer/line driver with 5-volt tolerant inputs/outputs 3-State

DESCRIPTION The 74LVC541A is a high performance, low-power, low-voltage Si-gate CMOS device and superior to most advanced CMOS compatible TTL families. Inputs can be driven from either 3.3V or 5.0V devices. In 3-State operation, outputs can handle 5V. This feature allows the use of these devices

OCTAL BUFFER/ LINE DRIVER WITH 3 STATE OUTPUTS

Description The 74LVC541A is an octal buffer/driver is designed for driving bus lines or buffer memory address registers. The 3-state control gate is a 2-input AND gate with active-low inputs so that, if either output enable (OE1 or OE2) input is high, all eight outputs are in the high-impedance

Octal buffer/line driver with 5 V tolerant inputs/outputs; 3-state

1. General description The 74LVC541A is an 8-bit buffer/line driver with 3-state outputs. The device features two output enables (OE1 and OE2). A HIGH on OEn causes the associated outputs to assume a high-impedance OFF-state . Inputs can be driven from either 3.3 V or 5 V devices. This feature

Low-Voltage CMOS Octal Buffer Flow Through Pinout

Low-Voltage CMOS Octal Buffer Flow Through Pinout With 5 V−Tolerant Inputs and Outputs (3−State, Non−Inverting) The 74LVC541A is a high performance, non−inverting octal buffer operating from a 1.2 to 3.6 V supply. This device is similar in function to the MC74LCX244, while providing flow through

Low-Voltage CMOS Octal Buffer Flow Through Pinout

文件：104.78 Kbytes Page：9 Pages