Features

Single 2.3V - 3.6V supply

Serial Peripheral Interface (SPI) compatible

Supports SPI modes 0 and 3

Supports RapidS™ operation

Continuous read capability through entire array

Up to 85MHz

Low-power read option up to 15MHz

Clock-to-output time (tV

) of 6ns maximum

User configurable page size

512 bytes per page (default)

528 bytes per page (customer selectable option)

Two fully independent SRAM data buffers (512/528 bytes)

Allows receiving data while reprogramming the main memory array

Flexible programming options

Byte/Page Program (1 to 512/528 bytes) directly into main memory

Buffer Write

Buffer to Main Memory Page Program

Flexible erase options

Page Erase (512/528 bytes)

Block Erase (4KB)

Sector Erase (128KB)

Chip Erase (16-Mbits)

128-byte Security Register

128 bytes factory programmed with a unique identifier

Hardware and software controlled reset options

JEDEC Standard Manufacturer and Device ID Read

Low-power dissipation

300nA Ultra-Deep Power-Down current (typical)

5µA Deep Power-Down current (typical)

25µA Standby current (typical)

7mA Active Read current (typical)

Endurance: 100,000 program/erase cycles per page minimum

Data retention: 20 years

Complies with full industrial temperature range

Green (Pb/Halide-free/RoHS compliant) packaging options

8-lead SOIC (0.150 wide and 0.208 wide)

8-pad Ultra-thin DFN (5 x 6 x 0.6mm)

Description

The Adesto®

AT25PE16 is a 2.3V or 2.5V minimum, serial-interface sequential access Flash memory ideally suited for a

wide variety of digital voice, image, program code, and data storage applications. The AT25PE16 also supports the

RapidS serial interface for applications requiring very high speed operation. Its 17,301,504 bits of memory are organized

as 4,096 pages of 512 bytes (default) or 528 bytes (customer option) each. In addition to the main memory, the

AT25PE16 also contains two SRAM buffers of 512/528 bytes each. The buffers allow receiving of data while a page in

the main memory is being reprogrammed. Interleaving between both buffers can dramatically increase a system's ability

to write a continuous data stream. In addition, the SRAM buffers can be used as additional system scratch pad memory,

and E2PROM emulation (bit or byte alterability) can be easily handled with a self-contained three step read-modify-write

operation.

Unlike conventional Flash memories that are accessed randomly with multiple address lines and a parallel interface, the

Adesto DataFlash-L®

uses a serial interface to sequentially access its data. The simple sequential access dramatically

reduces active pin count, facilitates simplified hardware layout, increases system reliability, minimizes switching noise,

and reduces package size. The device is optimized for use in many commercial and industrial applications where

high-density, low-pin count, low-voltage, and low-power are essential.

To allow for simple in-system re-programmability, the AT25PE16 does not require high input voltages for programming.

The device operates from a single 2.3V to 3.6V or 2.5V to 3.6V power supply for the erase and program and read

operations. The AT25PE16 is enabled through the Chip Select pin (CS) and accessed via a 3-wire interface consisting of

the Serial Input (SI), Serial Output (SO), and the Serial Clock (SCK).

All programming and erase cycles are self-timed.