位置:8T49N281C-003NLGI > 8T49N281C-003NLGI详情

8T49N281C-003NLGI中文资料

厂家型号

8T49N281C-003NLGI

文件大小

1671Kbytes

页面数量

70

功能描述

Tilera TILE-Gx72 & TILE-Gx9, Gx16, Gx36 & Gx72 Processor

数据手册

下载地址一下载地址二到原厂下载

生产厂商

RENESAS

8T49N281C-003NLGI数据手册规格书PDF详情

General Description

The 8T49N281-003 has a fractional-feedback PLL that can be used

as a jitter attenuator or frequency translator. It is equipped with six

integer and two fractional output dividers, allowing the generation of

up to 8 different output frequencies, ranging from 8kHz to 1GHz.

Three of these frequencies are completely independent of each other

and the inputs. The other five are related frequencies. The eight

outputs may select among LVPECL, LVDS or LVCMOS output levels.

This functionality makes it ideal to be used in any frequency

translation application, including 1G, 10G, 40G and 100G

Synchronous Ethernet, OTN, and SONET/SDH, including ITU-T

G.709 (2009) FEC rates. The device may also behave as a frequency

synthesizer.

The 8T49N281-003 accepts up to twodifferential or single-ended

input clocks and a crystal input. The PLL can lock to either input clock,

but both input clocks must be related in frequency.

The device supports hitless reference switching between input

clocks. The device monitors both input clocks for Loss of Signal

(LOS). It generates an alarm when an input clock failure is detected.

Automatic and manual hitless reference switching options are

supported. LOS behavior can be set to support gapped or un-gapped

clocks.

The 8T49N281-003 supports holdover with an initial accuracy of

±50ppB from the point where the loss of all applicable input

reference(s) has been detected. It maintains a historical average

operating point that may be returned to in holdover at a limited phase

slope.

The device places no constraints on input to output frequency

conversion, supporting all FEC rates, including the new revision of

ITU-T Recommendation G.709 (2009), most with 0ppm conversion

error.

The PLL has a register-selectable loop bandwidth from 0.5Hz to

512Hz.

Each output supports individual phase delay settings to allow

output-output alignment.

The device supports Output Enable inputs and Lock, Holdover and

LOS status outputs.

The device is programmable through an I2C interface. It also supports

I

2C master capability to allow the register configuration to be read

from an external EEPROM.

Features

• Supports SDH/SONET and Synchronous Ethernet clocks

including all FEC rate conversions

• Two differential outputs meet jitter limits for 100G Ethernet and

STM-256/OC-768

• <0.3ps RMS (including spurs): 12kHz to 20MHz

• All outputs <0.5ps RMS (including spurs) 12kHz to 20MHz

• Operating modes: locked to input signal, holdover and free-run

• Initial holdover accuracy of ±50ppb

• Accepts two LVPECL, LVDS, LVHSTL, HCSL or LVCMOS

input clocks

• Accepts frequencies ranging from 8kHz up to 875MHz

• Auto and manual input clock selection with hitless switching

• Clock input monitoring, including support for gapped clocks

• Phase-Slope Limiting and Fully Hitless Switching options to

control output phase transients

• Operates from a 10MHz to 40MHz fundamental-mode crystal

• Generates eight LVPECL, LVDS or sixteen LVCMOS output clocks

• Output frequencies ranging from 8kHz up to 1.0GHz (diff)

• Output frequencies ranging from 8kHz to 250MHz (LVCMOS)

• Four General Purpose I/O pins with optional support for status &

control:

• Four Output Enable control inputs may be mapped to any of the

eight outputs

• Lock, Holdover & Loss-of-Signal status outputs

• Open-drain Interrupt pin

• Programmable PLL bandwidth settings:

• 0.5Hz, 1Hz, 2Hz, 4Hz, 8Hz, 16Hz, 32Hz, 64Hz, 128Hz, 256Hz

or 512Hz

• Optional Fast Lock function

• Programmable output phase delays in steps as small as 16ps

• Register programmable through I2C or via external I2C EEPROM

• Bypass clock paths for system tests

• Power supply modes

VCC / VCCA / VCCO

3.3V / 3.3V / 3.3V

3.3V / 3.3V / 2.5V

3.3V / 3.3V / 1.8V (LVCMOS)

2.5V / 2.5V / 3.3V

2.5V / 2.5V / 2.5V

2.5V / 2.5V / 1.8V (LVCMOS)

• Power down modes support consumption as low as 1.5W (see

Section, “Power Dissipation and Thermal Considerations” for

details)

• -40°C to 85°C ambient operating temperature

• Package: 56QFN, lead-free RoHs (6)

更新时间:2025-12-6 10:46:00
供应商 型号 品牌 批号 封装 库存 备注 价格
Renesas
25+
电联咨询
7800
公司现货,提供拆样技术支持
Renesas
25+
25000
原厂原包 深圳现货 主打品牌 假一赔百 可开票!
RENESAS(瑞萨)/IDT
2447
VFQFPN-56(8x8)
315000
一级代理专营品牌!原装正品,优势现货,长期排单到货
RENESAS(瑞萨)/IDT
2021+
VFQFPN-56(8x8)
499
RENESAS(瑞萨)/IDT
24+
VFQFPN56(8x8)
7350
现货供应,当天可交货!免费送样,原厂技术支持!!!
Renesas Electronics America In
25+
56-VFQFN 裸露焊盘
9350
独立分销商 公司只做原装 诚心经营 免费试样正品保证
RENESAS ELECTRONICS
23+
SMD
880000
明嘉莱只做原装正品现货
RENESAS ELECTRONICS
24+
N/A
1868
原装原装原装
IDT
23+
当天发货
50000
全新原装正品现货,支持订货
IDT
当天发货
5
一级代理,专注军工、汽车、医疗、工业、新能源、电力