on 65 nm Process in the 775-land LGA Package supporting Intel 64 architecture

文件：1.48103 Mbytes Page：98 Pages

SINGLE OPERATIONAL AMPLIFIER WITH DARLINGTON INPUT

Features ● High input impedance ● Wide common-mode range ● Large supply-voltage range ● Large control range ● High output current ● Simple frequency compensation ● Wide temperature range (TCA 332) ● NPN Darlington input ● Open collector output Applications ● Amplifier ● Comparator ● L

DUAL OPERATIONAL AMPLIFIER

Features ● Wide common-mode range ● Large supply voltage range ● Wide temperature range (TAA 2762 A) ● High output current ● Large control range ● Internally frequency-compensated ● NPN input with protection diodes ● Open collector output Applications ● Amplifier ● Comparator ● Level c

LED Driver for Light Band Displays

Infrarot-Vorverstarker

TDA4050, TDA4050B DIP 8 Pin Datasheet, Pinouts

Single Operational Amplifiers

Single Operational Amplifiers

Video Switch, Bipolar IC

The TDA5850 is a switchable video amplifier with connections for the French and IEC VTR standards. Features ● Standard connection for VTR (CCIR) and Peri TV sets ● Input clamping ● Positve and negative video outputs

TV Stereo Matrix with Tape Recorder Connection

FM Receiver IC

FM Receiver IC The TBB 469 is an FM narrowband IC particularly intended for radio receivers. It is suited for the conversion, limiting , demodulation, and AF processing of an FM-modulated signal.

Single PNP-Operational Amplifiers

Single PNP-Operational Amplifiers These operational amplifiers are circuits for universal applications having a PNP-input differential stage and an open collector output. Apart from one resistor, only active components are used. The integrated regulator provides for all parameters a large degree

Dual PNP-Operational Amplifiers

Bipolar IC Features ● Supply voltage range between 3 V and 36 V ● Low current consumption, 0.8 mA typ. ● Extremely large control range ● Low output saturation voltage, almost independent of load current ● Output current up to 70 mA (max. 100 mA) ● Output virtually short-circuit proof ● Wid

Quad PNP-Operational Amplifier

The TAE 4453 / TAF 4453 consists of four independent, frequency-compensated opamps, each having a PNP-input differential stage and an open collector output. The integrated regulator provides for all parameters a large degree of independence of the supply voltage. Features ●Supply voltage r

Single PNP-Operational Amplifiers

Single PNP-Operational Amplifiers These operational amplifiers are circuits for universal applications having a PNP-input differential stage and an open collector output. Apart from one resistor, only active components are used. The integrated regulator provides for all parameters a large degree

Dual PNP-Operational Amplifiers

Bipolar IC Features ● Supply voltage range between 3 V and 36 V ● Low current consumption, 0.8 mA typ. ● Extremely large control range ● Low output saturation voltage, almost independent of load current ● Output current up to 70 mA (max. 100 mA) ● Output virtually short-circuit proof ● Wid

Quad PNP-Operational Amplifier

The TAE 4453 / TAF 4453 consists of four independent, frequency-compensated opamps, each having a PNP-input differential stage and an open collector output. The integrated regulator provides for all parameters a large degree of independence of the supply voltage. Features ●Supply voltage r

BIPOLAR IC

Bipolar IC Combined with a VCO (tuner) and a fast divider (dividing ratio 1:64), the ASBC technology component forms a digitally programmable phase-locked loop for television sets with PLL frequency synthesis tuning. The PLL enables crystal-controlled setting of the tuner oscillator frequency for

SINGLE OPERATIONAL AMPLIFIER WITH DARLINGTON INPUT

Features ● High input impedance ● Wide common-mode range ● Large supply-voltage range ● Large control range ● High output current ● Simple frequency compensation ● Wide temperature range (TCA 332) ● NPN Darlington input ● Open collector output Applications ● Amplifier ● Comparator ● L

Single Operational Amplifiers

Features ●Wide common-mode range ●Large supply voltage range ●Large control range ●Wide temperature range (TAA 762) ●High output frequency compensation ●Open collector output Applications ●Amplifier ●Comparator ●Level converter ●Driver

SINGLE OPERATIONAL AMPLIFIER WITH DARLINGTON INPUT

Features ● High input impedance ● Wide common-mode range ● Large supply-voltage range ● Large control range ● High output current ● Simple frequency compensation ● Wide temperature range (TCA 332) ● NPN Darlington input ● Open collector output Applications ● Amplifier ● Comparator ● L

Single Operational Amplifiers

Features ●Wide common-mode range ●Large supply voltage range ●Large control range ●Wide temperature range (TAA 762) ●High output frequency compensation ●Open collector output Applications ●Amplifier ●Comparator ●Level converter ●Driver

Single Operational Amplifiers

Single Operational Amplifiers

Proximity Switch

Features ● Lower open-loop current consumption; IS

Proximity Switch

Features ● Lower open-loop current consumption; IS

Phase Control IC

Phase Control IC Pb-free lead plating; RoHS compliant This phase control IC is intended to control thyristors, triacs, and transistors. The trigger pulses can be shifted within a phase angle between 0 ˚ and 180 ˚. Typical applications include converter circuits, AC controllers and three-phase

Control ICs for Switched-Mode Power Supplies

Features ●Direct control of the switching transistor ●Low start-up current ●Reversing linear overload characteristic ●Base current drive proportional to collector current ●Protective circuit in case of disturbance

Control ICs for Switched-Mode Power Supplies

Features ●Direct control of the switching transistor ●Low start-up current ●Reversing linear overload characteristic ●Base current drive proportional to collector current ●Protective circuit in case of disturbance

Single Operational Amplifiers

Single Operational Amplifiers

Proximity Switch

Features ● Lower open-loop current consumption; IS

TV Stereo Tone Control IC with Quasi-Stereo Section, > Channel 1/2 Switch, SCART Input, and I2C Bus Control

TV Stereo Tone Control IC with Quasi-Stereo Section, Channel 1/2 Switch, SCART Input, and I2C Bus Control

DUAL OPERATIONAL AMPLIFIER

Features ● Wide common-mode range ● Large supply voltage range ● Wide temperature range (TAA 2762 A) ● High output current ● Large control range ● Internally frequency-compensated ● NPN input with protection diodes ● Open collector output Applications ● Amplifier ● Comparator ● Level c

Single Operational Amplifiers

Single Operational Amplifiers

Mixers

Features ● Versatile application ● Wide ragne of supply voltage ● Few external components ● High conversion transconductance ● Low noise figure

Control IC for Switched-Mode Power Supplies using MOS-Transistors

Features ● Fold-back characteristics provides overload protection for external components ● Burst operation under secondary short-circuit condition implemented ● Protection against open or a short of the control loop ● Switch-off if line voltage is too low (undervoltage switch-off) ● Line vol

Stereo Decoder/Noise Blanker

Features • Internal reference voltage source • Adjustment free oscillator with ceramic resonator 456 kHz • Pilot dependent mono/stereo switching with hysteresis • Stereo indicator output • Analogue control of mono/stereo change over (stereo noise control, SNC) • Pilot canceller (19 kHz) • A

Control IC for Switched-Mode Power Supplies using MOS-Transistor

The IC TDA 4605-3 controls the MOS-power transistor and performs all necessary control and protection functions in free running flyback converters. Because of the fact that a wide load range is achieved, this IC is applicable for consumer as well as industrial power supplies. The serial circuit a

Control IC for Switched-Mode Power Supplies using MOS-Transistors

The IC TDA 4605-3 controls the MOS-power transistor and performs all necessary control and protection functions in free running flyback converters. Because of the fact that a wide load range is achieved, this IC is applicable for consumer as well as industrial power supplies. The serial circuit a

Multistandard Sound IF

Features ● Sound carrier mixer ● VCO ● Programmable Divider ● Reference divider with crystal oscillator ● Phase comparator ● Operational amplifier for PLL filter ● I2C bus interface ● 3 identical FM channels with limiter amplifiers and coincidence demodulators.

AF-AMPLIFIER FOR TELEVISION SETS

Functional Description This device is a short-circuit proof AF-amplifier with minimal external circuitry requirements. It offers a standby function that insures no audible switch on/off noise.

Video and Sound IF with FM-PLL Demodulator, AFC and V & S SCART

Features ●Features video and sound IF ●Video and sound SCART ●AFC ●NTSC option

Video IF with FPLL, MAC State

Bipolar IC Circuit Description The IF circuit consists of a four-stage capacitively coupled and symmetrically designed controlled amplifier and a real synchronous demodulator with a FPLL-carrier regeneration. Two IF inputs can be selected for applications with different SAWs. The main perf

Dual Sound FM IF Amplifier

Features ● High AM suppression over a very wide input voltage range ● High sensitivity ● Very high symmetry

Video IF Amplifier and Demodulator with Full-SCART

Functional Description Video IF for all European standards for positive and negative modulation. The video section contains a Full-SCART interface. An output for the demodulated video signal (pin 9) allows the insertion of a sound trap into the signal path to the input or the SCART switch and the

FM-Sound IF with SCART Switch and Volume Control

Functional Description FM-IF amplifier, consisting in a limiter amplifier with FM demodulator. The AF section contains a SCART-record/playback switch as well as AF output with volume control. The control of the volume is controlled via an analog control input, and the SCART switch is controlled v

Video and Sound IF with V & S SCART

Features ● Features video / sound scart ● Active FM-PLL demodulator ● AF control ● Alignment - free sound IF

Video Modulator for FM-Audio

Features ● FM-audio modulator ● Sync level clamping of video input signal ● Controlling of peak white value ● Continuous adjustment of modulation depth for positive or negative values ● Symmetrical mixer output with separate ground area ● Symmetrical oscillator with separate RF-ground ● Low

Dual Conversion AM Receiver

Features • High flexibility with an external preamplifier stage • Sym. or asym. mixer input • 2-pin oscillator for the 1. LO • 1. LO with LC tank circuit • 1. LO at 100 MHz range • Low narrow band noise • Divider for 1. LO by 10 for the 100 kHz … 2 MHz range and by 8 for the 2 MHz … 6 MHz r

Audioprocessor

Overview The TDA 4390-2X is a single-chip audio sound system. The circuit can be partitioned into two functional blocks. Features 1. Stereo sound processing • Four stereo AF inputs • Input/Output interface for external equalizer • Max. gain switchable between 0 dB and 6 dB •

Multistandard Sound IF

Features ● Sound carrier mixer ● VCO ● Programmable Divider ● Reference divider with crystal oscillator ● Phase comparator ● Operational amplifier for PLL filter ● I2C bus interface ● 3 identical FM channels with limiter amplifiers and coincidence demodulators.

Decoder for Program Delivery Control and Video Program System PDC / VPS Decoder

Functional Description The CMOS circuit SDA 5648 is intended for use in video cassette recorders to retrieve control data of the PDC system from the data lines broadcast during the vertical blanking interval of a standard video signal. Features ● Single-chip receiver for PDC data, broadcast eit

7 x 5 Video Matrix Switch

General Description The TDA 6920 switches 7 video input sources to 5 outputs. Each output can be switched to only one input, but one input can be switched to all outputs. The C-input may be combined with one CVBS input as Y for Y+C (S-VHS) operation. Y+C operation is selected by bus. Features ●

Single Operational Amplifiers

Features ●Wide common-mode range ●Large supply voltage range ●Large control range ●Wide temperature range (TAA 762) ●High output frequency compensation ●Open collector output Applications ●Amplifier ●Comparator ●Level converter ●Driver

THRESHOLD SWITCH

Features ● Wide range of supply voltage, 4.5 to 30 V ● High output current, 50 mA ● TTL-compatible ● Triggerable with DC signal

SINGLE OPERATIONAL AMPLIFIER WITH DARLINGTON INPUT

Features ● High input impedance ● Wide common-mode range ● Large supply-voltage range ● Large control range ● High output current ● Simple frequency compensation ● Wide temperature range (TCA 332) ● NPN Darlington input ● Open collector output Applications ● Amplifier ● Comparator ● L

THRESHOLD SWITCH

Features ● Wide range of supply voltage, 4.5 to 30 V ● High output current, 50 mA ● TTL-compatible ● Triggerable with DC signal

Single Operational Amplifiers

Features ●Wide common-mode range ●Large supply voltage range ●Large control range ●Wide temperature range (TAA 762) ●High output frequency compensation ●Open collector output Applications ●Amplifier ●Comparator ●Level converter ●Driver

2-GHz-Mixer

The PMB 2330 is a low power, monolithic, double balanced mixer similar to S 042 P and TBB 042 G for frequencies up to 2 GHz. Features ● Few external components ● Low noise ● Low spurious signal content ● High conversion transconductance ● Very highly isolated RF, IF and LO port

2-GHz-Mixer

The PMB 2330 is a low power, monolithic, double balanced mixer similar to S 042 P and TBB 042 G for frequencies up to 2 GHz. Features ● Few external components ● Low noise ● Low spurious signal content ● High conversion transconductance ● Very highly isolated RF, IF and LO port

FM IF IC WITH SEARCH TUNING STOP PULSE, FIELD STRENGTH INDICATOR, MUTE SETTING AND MULTIPATH

FM IF IC WITH SEARCH TUNING STOP PULSE, FIELD STRENGTH INDICATOR, MUTE SETTING AND MULTIPATH

SMPS - IC with SIPMOS Driver Output

Functional Description The versatile switch-mode power supply ICs for the direct control of SIPMOS power transistors comprise digital and analog functions. These functions are required for the design of high-quality flyback and forward converters during single-phase and push-pull operation in nor

SMPS - IC with SIPMOS Driver Output

Functional Description The versatile switch-mode power supply ICs for the direct control of SIPMOS power transistors comprise digital and analog functions. These functions are required for the design of high-quality flyback and forward converters during single-phase and push-pull operation in nor