DESCRIPTION

The SA5200 is a dual amplifier with DC to 1200MHz response. Low noise (NF = 3.6dB) makes this part ideal for RF front-ends, and a simple power-down mode saves current for battery operated equipment. Inputs and outputs are matched to 50Ω. The enable pin allows the designer the ability to turn the amplifiers on or off, allowing the part to act as an amplifier as well as an attenuator. This is very useful for front-end buffering in receiver applications.

FEATURES

•Dual amplifiers

•DC - 1200MHz operation

•Low DC power consumption (4.2mA per amplifier @ VCC= 5V)

•Power-Down Mode (ICC= 95µA typical)

•3.6dB noise figure at 900MHz

•Unconditionally stable

•Fully ESD protected

•Low cost

•Supply voltage 4-9V

•Gain S21= 7dB at f = 1GHz

•Input and output match S11, S22typically

APPLICATIONS

•Cellular radios

•RF IF strips

•Portable equipment