MN101CB6 Series

■ Interrupts

RESET. Watchdog. External 0 to 4. Timer 0 to 3. Timer 7 (2 systems).

Time base. Serial 0 (2 systems). A/D conversion finish

■ Timer Counter

8-bit timer × 5

Timer 0 ..................Square-wave/8-bit PWM output. Event count.

Simple pulse width measurement. Added pulse (2-bit) type PWM

output. Square-wave/PWM output to large current terminal P35 possible

Timer 1 ..................Serial 0 baud rate timer

Timer 2 ..................Square-wave output. Added pulse (2-bit) type PWM output.

PWM output. Event count. Simple pulse width

measurement. Serial 0 baud rate timer.

Square-wave/PWM output to large current terminal P34 possible

Timer 3 ..................Interval timer

Timer 6 ..................8-bit freerun timer

Timer 0, 1 can be cascade-connected

Timer 2, 3 can be cascade-connected

16-bit timer × 1

Timer 7 ..................Square-wave output. 16-bit PWM output

(cycle/duty continuous variable). Event count. Pulse width measurement.

Input capture. Square-wave/PWM output to large current terminal P33 possible

Time base timer: One-minute count setting

Watchdog timer × 1

Watchdog timer 2 × 1

■ Serial interface

Synchronous type/UART (full-duplex) × 1: Serial 0

■ I/O Pins

I/O 17 : Common use. Specified pull-up resistor available.

Input/output selectable (bit unit)

■ A/D converter

10-bit × 5 channels (with S/H)

■ Special Ports

High-current drive port

■ ROM Correction

Correcting address designation: Up to 3 addresses possible

■ Gain Amplifier

2 channels

■ Reference Power Supply Output

1.7 V: Output to REF17 terminal possible. Supply to A/D converter input,

A/D converter reference voltage and a reference power for

Double Booster Circuit possible

■ Double Booster Circuit

Counle boosts REF17 terminal input voltage

or Reference Power Supply Output

■ Reset

Automatic Reset

■ Internal oscillation

High speed: 8 MHz. Low speed: 20 kHz