FNB33060T is an advanced Motion SPM 3 module providing

a fully−featured, high−performance inverter output stage for AC

Induction, BLDC, and PMSM motors. These modules integrate

optimized gate drive of the built−in IGBTs to minimize EMI

and losses, while also providing multiple on−module protection

features including under−voltage lockouts, over−current shutdown,

thermal monitoring of drive IC, and fault reporting. The built−in,

high−speed HVIC requires only a single supply voltage and translates

the incoming logic−level gate inputs to the high−voltage, high−current

drive signals required to properly drive the module’s internal IGBTs.

Separate negative IGBT terminals are available for each phase

to support the widest variety of control algorithms.

Features

• 600 V − 30 A 3−Phase IGBT Inverter with Integral Gate Drivers

and Protection

• Low−Loss, Short−Circuit Rated IGBTs

• Very Low Thermal Resistance Using Al2O3 DBC Substrate

• Built−In Bootstrap Diodes and Dedicated Vs Pins Simplify

PCB Layout

• Separate Open−Emitter Pins from Low−Side IGBTs for

Three−Phase Current Sensing

• Single−Grounded Power Supply

• LVIC Temperature−Sensing Built−In for Temperature

Monitoring

• Isolation Rating: 2500 Vrms / min

• This Device is Pb−Free and Halide Free

Applications

• Motion Control − Home Appliance / Industrial Motor

Integrated Power Functions

• 600 V − 30 A IGBT Inverter for Three−phase DC / AC Power

Conversion (Please refer to Figure 2)

Integrated Drive, Protection and System Control Functions

• For Inverter High−side IGBTs: gate drive circuit, high−voltage

isolated high−speed level shifting control circuit Under−Voltage

Lock−Out Protection (UVLO)

(Note: Available bootstrap circuit example is given in Figures 5

and 15)

• For Inverter Low−side IGBTs: gate drive circuit, Short−Circuit

Protection (SCP) control supply circuit Under−Voltage Lock−Out

protection (UVLO)

• Fault Signaling: corresponding to UVLO (low−side supply) and SC

faults

• Input Interface: Active−HIGH interface, works with 3.3 / 5 V logic,

Schmitt−trigger input