1 General description

P3T1084UK is a temperature-to-digital converter with a -40 °C to +125 °C range. It uses an on-chip band gap temperature sensor and A-to-D conversion technique with overtemperature detection. The device contains a number of data registers, including a Configuration register (Conf) to store the device settings (such as device operation mode), and a temperature register (Temp) to store the digital temp reading, which can be communicated by a controller via the 2-wire serial I3C (up to 12.5 MHz) and I2C (up to 3.4 MHz) interface. The I2C interface supports up to four target addresses and an alert function which becomes active when the temperature exceeds the programmed limits. The I3C interface supports IBI (In Band Interrupt) where P3T1084UK emits its address into the arbitrated address header on the I3C bus to notify the controller of an interrupt. It does not require an additional interrupt pin. P3T1084UK can be configured for different operation conditions. It can be set in normal mode to periodically monitor the ambient temperature, or in shut-down mode to minimize power consumption. The temperature register always stores a 12 bit two's complement data, giving a temperature resolution of 0.0625°C.

2 Features and benefits

• I3C (up to 12.5 MHz) and I2C (up to 3.4 MHz) interface

• Supply range: 1.4 V to 3.6 V

• Programmable undertemperature and overtemperature alerts

• Resolution: 12 bits (0.0625 °C)

• Accuracy:

– 1.4 V < VCC < 3.6 V

– ±0.4 °C (maximum) from –20 °C to +85 °C

– ±1 °C (maximum) from -40 °C to +125 °C

• Low quiescent current: 6 μA supply current

• ESD protection exceeds 2000 V HBM per JESD22-A114 and 1000 V CDM per JESD22-C101

• Package:

– WLCSP6, 1.18 mm × 0.84 mm package

3 Applications

• Portable devices

• System thermal management

• SSD

• Industrial controllers

• Servers

• PC/Notebook