Features

603e series processor core that implements the PowerPC architecture

• Superscalar architecture

• 0 – 231MHz static operation (extended temperature range)

• 16K Instruction/16K Data Caches

• Double precision FPU

• Instruction and Data MMU

• Dynamic power management including Doze and Sleep modes

• True little endian and big endian support

• Standard & critical interrupt capability

High speed SDRAM memory interface

• 66MHz operation

• SDRAM & DDR SRAM support

• 128Mbyte addressing range

• 32-bit data bus

• Built-in initialization and refresh

Flexible multi-function external bus

• Supports PCI, ATA/IDE, and ROM/RAM/Flash interfaces

• Version 2.2 PCI master compatibility

– 32-bit muxed address/data

– 33MHz operation with SmartComm‘ enabled

• Version 4 ATA compatible external interface

– IDE Disk Drive connectivity

• ROM/RAM/Flash interface

– Boot ROM, external peripheral connectivity

SmartComm I/O subsystem

• SmartComm virtual DMA controller

• Dedicated DMA channels for reception and transmission for all peripheral

interfaces

• Programmable Serial Controllers (PSCx)

– UART or RS232 interface

– CODEC interface for modem or AC97 audio

– Bluetooth, cellular, GPS, digital radio interface

• 10/100 BaseT Ethernet

• USB Master 1.1 with OHCI support

– Support for two independent USB ports

• Infrared (IR) data port

– Two IR receive ports (Standard IR & IrDA)

– IRBlaster

– IrDA 1.0 SIR mode to 115.2kbps

– IrDA 1.1 MIR and FIR modes to 4.0Mbps

• I2C Controller(s) to 520Kbps

– Support for two independent I2C ports

• Serial Peripheral Interface (SPI) controller

Dual MSCAN 2.0 A/B Controller modules

• Motorola Scalable Controller Area Network (MSCAN) architecture

• V2.0 A/B CAN protocol

• Standard and extended data frames

• Programmable bit rate up to 1Mbps (High Speed or Low Speed)

System level features

• Six programmable chip selects

• Interrupt controller

– Four external interrupt request lines supporting standard and/or critical

interrupts

– Support for all other internal interrupt sources

• GPIO / Timer functions

– Two dedicated GPIO pins supporting WakeUp capability

– Eight dedicated GPIO pins with timer capability supporting input capture,

output compare, and Pulse Width Modulation (PWM) functions

– Up to 56 total GPIO pins (depending on functional muxing selections)

• Systems Protection (watch dog timer, bus monitor)

• Real-time clock

• Power management features

Test / Debug features

• JTAG (IEEE 1149.1 test access port)

• Common On-Chip Processor (COP) debug port

On-board PLL and clock generation

Software Development Support

• Complete software development tool chain

• Optional accessory development kits

• Robust silicon evaluation kits

• Technical support

• Professional services