Description:

The NTE309K is a complete 5V regulator fabricated on a single silicon chip. It is designed for local

regulation on digital logic cards, eliminating the distribution problems associated with single–point

regulation. With the TO3 power package, the available output current is greater than 1A.

The regulator is essentially blowout proof. Current limiting is included to limit the peak output current to a safe value. In addition, the thermal shutdown is provided to keep the IC from overheating. If internal dissipation becomes too great, the regulator will shut down to prevent excessive heating.

Considerable effort was expended to make these devices easy to use and to minimize the number

of external components. It is not necessary to bypass the output, although this does improve transient response somewhat. Input bypassing is needed, however, if the regulator is located very far from the filter capacitor of the power supply. Stability is also achieved by methods that provide very good rejection of load or line transients as are usually seen with TTL logic.

Although designed primarily as a fixed–voltage regulator, the output can be set to voltages above 5V, as shown below. It is also possible to use the circuits as the control element in precision regulators, taking advantage of the good current–handling capability and the thermal overload protection.

Features:

Specified to be compatible, worst case, with TTL and DTL

Output current in excess of 1A

Internal thermal overload protection

No external components required