Single Supply Quad Comparators

These comparators are designed for use in level detection, low−level sensing and memory applications in consumer, automotive, and industrial electronic applications. Features • Single Supply Operation: 3.0 V to 36 V • Split Supply Operation: ±1.5 V to ±18 V • Low Input Bias Current: 25 nA

Single Supply Quad Comparators

文件：159.87 Kbytes Page：12 Pages

Single Supply Quad Comparators

文件：119.7 Kbytes Page：11 Pages

Insert Molded Coil

Features: 1. Plastic molded. 2. High reliability. 3. Low cost. Measurement: 1. Q and L measured with ½” long of TCW#16 soldered along the coil leads and with one end flush with the bottom of the coil then bent ¼” down from stand off at an angle of 90°. 2. L min. measured with core halfway ou

Size C Aluminum Box With Cover

Size C Aluminum Box Wit Cover

110 MHz Center Frequency

General Description KR 2901 is a 110 MHz bandpass filter. The filter has a typical 1 dB bandwidth of 16 MHz. Other passband frequencies are available. Please consult the factory. Features ● 110 MHz Center Frequency ● 16 MHz 1 dB Bandwidth ● SMA Connectors ● 50 Ω Source and Load

HiFiBerry DAC HAT - Standard RCA

o Dedicated 192kHz/24bit high-quality Burr-Brown DAC for best sound quality o Hardware volume control. You can control the output volume using “alsamixer” or any application that supports ALSA mixer controls o Directly powered from the Raspberry Pi, no additional power supply o Ultra-low-noise

High Temperature Low Power Quad Voltage Comparators

Description This device consists of four independent precision voltage comparators. All these comparators are designed specifically to operate from a single power supply over a wide range of voltages. Operation from split power supplies is also possible. These comparators also have a unique