Introduction

The Hall programmer board V 5.1 is a general-purpose programming interface which is capable of addressing the programmable Micronas Hall-effect sensor families HAL 8xy and HAL 100x.

The Hall programmer board V 5.1 is fully software compatible to the Hall programmer board V 4.1. Hence, it is possible to replace older boards by V 5.1 while keeping the software programmer.

Features

– Communication with a PC by serial interface (RS232)

– Data transfer to/from PC board at a Baud rate of up to 57600

– Supervised programming of the Hall-effect sensors

– Output voltage level control

– Up to four Hall-effect sensors can be connected in parallel

– Easy firmware upgrade possible