Highlights

• Non-blocking wire-speed Ethernet switching fabric

• Full-featured forwarding and filtering control, including Access Control List (ACL) filtering

• Full VLAN and QoS support

• Five ports with integrated 10/100BASE-T PHY transceivers with optional Quiet-WIRE® EMC filtering

• Two ports with 10/100/1000 Ethernet MACs and configurable RGMII/MII/RMII interfaces

• IEEE 1588v2 Precision Time Protocol (PTP) support

• IEEE 802.1AS/Qav Audio Video Bridging (AVB)

• IEEE 802.3az Energy Efficient Ethernet (EEE)

• IEEE 802.1X access control support

• EtherGreen™ power management features,

including low power standby

• Flexible management interface options: SPI, I2C,

MIIM, and in-band management via any port

• Industrial/Extended Auto temperature range support

• 128-pin TQFP-EP (14 x 14mm) RoHS compliant pkg

Target Applications

• Industrial Ethernet (Profinet, MODBUS, Ethernet/IP)

• Real-time Ethernet networks

• IEC 61850 networks w/ power substation automation

• Industrial control/automation switches

• Networked measurement and control systems

• Test and measurement equipment

Features

• Switch Management Capabilities

- 10/100Mbps Ethernet switch basic functions: frame

buffer management, address look-up table, queue

management, MIB counters

- Non-blocking store-and-forward switch fabric assures

fast packet delivery by utilizing 4096 entry forwarding

table with 256kByte frame buffer

- Jumbo packet support up to 9000 bytes

- Port mirroring/monitoring/sniffing:

ingress and/or egress traffic to any port

- Rapid spanning tree protocol (RSTP) support for topology management and ring/linear recovery

- Multiple spanning tree protocol (MSTP) support

• Two Configurable External MAC Ports

- Reduced Gigabit Media Independent Interface

(RGMII) v2.0

- Reduced Media Independent Interface (RMII) v1.2

with 50MHz reference clock input/output optionvm

- Media Independent Interface (MII) in PHY/MAC mode

• Five Integrated PHY Ports

- 100BASE-TX/10BASE-T/Te IEEE 802.3

- Fast Link-up option significantly reduces link-up time

- Auto-negotiation and Auto-MDI/MDI-X support

- Energy-Efficient Ethernet (EEE) support with lowpower idle mode and clock stoppage

- On-chip termination resistors and internal biasing for

differential pairs to reduce power

• Advanced Switch Capabilities

- IEEE 802.1Q VLAN support for 128 active VLAN

groups and the full range of 4096 VLAN IDs

- IEEE 802.1p/Q tag insertion/removal on per port basis

- VLAN ID on per port or VLAN basis

- IEEE 802.3x full-duplex flow control and half-duplex

back pressure collision control

- IEEE 802.1X access control (Port and MAC address)

- IGMP v1/v2/v3 snooping for multicast packet filtering

- IPv6 multicast listener discovery (MLD) snooping

- IPv4/IPv6 QoS support, QoS/CoS packet prioritization

- 802.1p QoS packet classification with 4 priority queues

- Programmable rate limiting at ingress/egress ports

• IEEE 1588v2 PTP and Clock Synchronization

- Transparent Clock (TC) with auto correction update

- Master and slave Ordinary Clock (OC) support

- End-to-end (E2E) or peer-to-peer (P2P)

- PTP multicast and unicast message support

- PTP message transport over IPv4/v6 and IEEE 802.3

- IEEE 1588v2 PTP packet filtering

- Synchronous Ethernet support via recovered clock

• Audio Video Bridging (AVB)

- Compliant with IEEE 802.1BA/AS/Qat/Qav standards

- Priority queuing,

- gPTP time synchronization, credit-based traffic shaper

• Comprehensive Configuration Registers Access

- High-speed 4-wire SPI (up to 50MHz), I2C interfaces

provide access to all internal registers

- MII Management (MIIM, MDC/MDIO 2-wire) Interface

provides access to all PHY registers

- In-band management via any of the data ports

- I/O pin strapping facility to set certain register bits from

I/O pins at reset time

• Power Management

- IEEE 802.3az Energy Efficient Ethernet (EEE)

- Energy detect power-down mode on cable disconnect

- Dynamic clock tree control

- Unused ports can be individually powered down

- Full-chip software power-down

- Wake-on-LAN (WoL) standby power mode with PME

interrupt output for system wake upon triggered events