GENERAL DESCRIPTION

The MX25L3205A is a CMOS 33,554,432 bit serial eLiteFlashTM Memory, which is configured as 4,194,304 x 8 internally. The MX25L3205A features a serial peripheral interface and software protocol allowing operation on a simple 3- wire bus. The three bus signals are a clock input

(SCLK), a serial data input (SI), and a serial data output (SO). SPI access to the device is enabled by CS# input.

GENERAL

• Serial Peripheral Interface (SPI) compatible -- Mode 0 and Mode 3

• 33,554,432 x 1 bit structure

• 64 Equal Sectors with 64K byte each

- Any sector can be erased

• Single Power Supply Operation

- 2.7 to 3.6 volt for read, erase, and program operations

• Latch-up protected to 100mA from -1V to Vcc +1V

• Low Vcc write inhibit is from 1.5V to 2.5V

PERFORMANCE

• High Performance

- Fast access time: 50MHz serial clock (30pF + 1TTL Load)

- Fast program time: 3ms/page (typical, 256-byte per page)

- Fast erase time: 1s/sector (typical, 64K-byte per sector) and 64s/chip (typical)

- Acceleration mode:

- Program time: 2.4ms/page (typical)

- Erase time: 0.8s/sector (typical) and 51s/chip (typical)

• Low Power Consumption

- Low active read current: 30mA (max.) at 50MHz

- Low active programming current: 30mA (max.)

- Low active erase current: 38mA (max.)

- Low standby current: 50uA (max.)

- Deep power-down mode 1uA (typical)

• Minimum 10K erase/program cycle for array

• Minimum 100K erase/program cycle for additional 4Kb