PCB Terminal Blocks with Wire Guard

BlockMaster Electronic’s Wire Guard Terminal Blocks have a variety of amperage, terminal sizes, and pole ranges to suit the needs of your projects.\n\n

This specification applies to – MTSXX009 – Terminal Block

文件：165.25 Kbytes Page：1 Pages

1.8cm (0.7-inch) NTSC/PAL Color LCD Panel

Description The LCX009AK is a 1.8cm diagonal active matrix TFT-LCD panel addressed by the polycrystalline silicon super thin film transistors with built-in peripheral driving circuit. This panel provides fullcolor representation in NTSC/PAL mode. RGB dots are arranged in a delta pattern featuring

QwikRadio Low-Power UHF Receiver

General Description The MICRF009 is a single chip, ASK/OOK (ON-OFF Keyed) RF receiverIC. It provides thesamefunction but with performance enhancements over earlier QwikRadio® receivers. Two key improvements are: higher sensitivity (typically 6dBhigher than the MICRF002) andfaster recovery

DUAL ASYMETRICAL TRANSIENT SUPPRESSOR FOR XDSL AND DATA LINES

DESCRIPTION This Thyristor Surge Suppressor device has been especially designed to protect against overvoltage. Two diodes clamp positive overloads while negative surges are suppressed by two protection thyristors. Particular attention has been given to the internal wire bonding. The ”4-point” c

DUAL ASYMETRICAL TRANSIENT SUPPRESSOR FOR XDSL AND DATA LINES

DESCRIPTION This Thyristor Surge Suppressor device has been especially designed to protect against overvoltage. Two diodes clamp positive overloads while negative surges are suppressed by two protection thyristors. Particular attention has been given to the internal wire bonding. The ”4-point” c

Low-Side Power Switch for Use in Solenoid,Lamp Drive Applications

Low-Side Power Switch for Use in Solenoid,Lamp Drive Applications ExPD (Excellent Power Device)