2 Watts 2:1 Wide Input Range SIP DC/DC Converter

The MINMAX MCW1000 series is a range of isolated 2W DC-DC converter modules featuring fully regulated output and wide 2:1 input voltage ranges.The product comes in a SIP-8 package with a very small footprint occupying only 2.0 cm2 (0.3 square in.) on the PCB.An excellent efficiency allows an operati • 工业标准SIP-8包装\n\n• 2:1宽输入电压范围\n\n• 全稳压输出\n\n• 隔离耐压1000VDC\n\n• 工作环境温度范围：-40℃至+85℃\n\n• 具备输入低电压、输出过电流、输出短路保护机制\n\n• 具备遥控开关功能\n\n• 通过国际安规UL/cUL/IEC/EN 62368-1(60950-1)认证;

2 Watts 2 :1 Wide Input Range DC/DC Converters Single Outputs

文件：173.91 Kbytes Page：8 Pages

High Power Density in SIP-8 Package

文件：494.62 Kbytes Page：4 Pages

DC/DC CONVERTER 2W High Power Density in SIP-8 Package

文件：603.18 Kbytes Page：4 Pages

System Controller for Compact Disc Players

Description The CXP1042Q is a 4-bit single chip microcomputer based on the SPC500 series. It incorporates programs in firmware for CD operations. It can be connected directly to the CDL-500 series of LSIs for CD players, and can directly drive LCDs, in addition to other features. It can be employ

EPITAXIAL PLANAR PNP TRANSISTOR (GENERAL PURPOSE)

GENERAL PURPOSE APPLICATION. FEATURES • Low Collector-Emitter Saturation Voltage : VCE(sat)=-2.0V(Max.). • Complementary to KTC2022D/L.

STEPPER MOTOR DRIVER

Stepper Motor Driver The SAA1042 drives a two–phase stepper motor in the bipolar mode. The device contains three input stages, a logic section and two output stages. The IC is contained in a 16 pin dual–in–line heat tab plastic package for improved heatsinking capability. The center four gr

STEPPER MOTOR DRIVER

Stepper Motor Driver The SAA1042 drives a two–phase stepper motor in the bipolar mode. The device contains three input stages, a logic section and two output stages. The IC is contained in a 16 pin dual–in–line heat tab plastic package for improved heatsinking capability. The center four gr

Fluid Level Detector

文件：170.93 Kbytes Page：8 Pages