AlGaAs LED/ Phototransistor Optocoupler

DESCRIPTION The MCT5210/5211 are optocouplers with a high efficiency AlGaAs LED optically coupled to a NPN phototransistor. The high performance LED makes operation at low input currents practical. The coupler is housed in a double molded, six pin DIP package. Isolation test voltage is 5300 VACRM

LOW INPUT CURRENT PHOTOTRANSISTOR OPTOCOUPLERS

Description The MCT52XX series consists of a high-efficiency AlGaAs, infrared emitting diode, coupled with an NPN phototransistor in a six pin dual-in-line package. The MCT52XX is well suited for CMOS to LSTT/TTL interfaces, offering 250 CTRCE(SAT) with 1 mA of LED input current. When an LED inp

Optocoupler, Phototransistor Output, Low Input Current, With Base Connection

DESCRIPTION The MCT521/5211 are optocouplers with a high efficiency AIGaAs LED optically coupled toa NPN phototransistor. The high performance LED makes operation at low input currents practical. The coupler is housed in a six pin DIP package. Isolation test voltage is 5300 VRMS. Because these pa

LOW INPUT CURRENT PHOTOTRANSISTOR OPTOCOUPLERS

Description\nThe MCT52XX series consists of a high-efficiency AlGaAs, infrared emitting diode, coupled with an NPN phototransistor in a six pin dual-in-line package.\nThe MCT52XX is well suited for CMOS to LSTT/TTL interfaces, offering 250% CTRCE(SAT) with 1 mA of LED input current. When an LED • High CTRCE(SAT) comparable to Darlingtons\n• CTR guaranteed 0°C to 70°C\n• High common mode transient rejection 5kV/µs\n• Data rates up to 150 kbits/s (NRZ)\n• Underwriters Laboratory (UL) recognized (file #E90700)\n• VDE recognized (file #94766)\n   – Add option 300 (e.g., MCT5211.300)Application;

Optocoupler, Phototransistor Output, Low Input Current, With Base Connection

HIGH-PERFORMANCE AIGAAS PHOTOTRANSISTOR OPTOCOUPLERS

文件：553.8 Kbytes Page：6 Pages

Low Input Current Phototransistor Optocouplers

Description The MCT52XXM series consists of a high-efficiency AlGaAs, infrared emitting diode, coupled with an NPN phototransistor in a six pin dual-in-line package. The MCT52XXM is well suited for CMOS to LSTT/TTL interfaces, offering 250 CTRCE(SAT) with 1mA of LED input current. When an LED in

6 引脚 DIP 低输入电流光电晶体管输出光耦合器

MCT52XXM系列包括一个高效率砷化铝镓红外线发光二极管，与一个NPN光电晶体管耦合，采用一个六引脚双列直插封装。MCT52XXM非常适合CMOS到LSTT/TTL的接口，提供250% CTR CE(SAT)，LED输入电流为1mA。 当LED输入电流加载为1.6mA时，数据速率可高达20K bits/s。MCT52XXM能简单地将LSTTL与LSTTL/ TTL连接，并且通过使用一个外部基级到发射器电阻达到高达100K bits/s的数据速率。 •与达灵顿相比高CTRCE(SAT)\n•CTR保证0°C到70°C\n•高共模瞬变抑制：5kV/µs\n•数据速率最高可达150kbits/s (NRZ)\n•获得保险商实验室(UL)认证（文件编号E90700，第2卷）\n•已获IEC60747-5-2认证（订购选项V）;

Low Input Current Phototransistor Optocouplers

文件：293.2 Kbytes Page：12 Pages

封装/外壳：6-SMD，鸥翼 包装：管件 描述：OPTOISO 5.3KV TRANS W/BASE 6SMD 隔离器 光隔离器 - 晶体管，光电输出

Transimpedance amplifier 280MHz

DESCRIPTION The NE5210 is a 7kΩ transimpedance wide band, low noise amplifier with differential outputs, particularly suitable for signal recovery in fiber-optic receivers. The part is ideally suited for many other RF applications as a general purpose gain block. FEATURES • Low noise: 3.5pA/√Hz

Silicon NPN epitaxial planer transistor

Silicon NPN epitaxial planar type ​​​​​​​ For digital circuits ■ Features • Costs can be reduced through downsizing of the equipment and reduction of the number of parts • S-Mini type package, allowing automatic insertion through the tape packing and magazine packing

PROGRAMMABLE SYNCHRONOUS-BUCK REGULATOR CONTROLLER

文件：417.02 Kbytes Page：29 Pages

PROGRAMMABLE SYNCHRONOUS-BUCK REGULATOR CONTROLLER

文件：417.02 Kbytes Page：29 Pages