SWITCHING REGULATOR CONTROLLER

■LOW VOLTAGE DUAL PWM SWITCHING REGULATOR CONTROLLER The MB3775 is a dual pulse-width-modulation control circuit. It contains the basic circuits required for two PWM control circuits. Complete synchronization is obtained by using the same oscillator output waveform. This IC can provide fo

开关稳压器控制器

The MB3775 is a dual pulse-width-modulation control circuit. It contains the basic circuits required for two PWM control circuits. Complete synchronization is obtained by using the same oscillator output waveform. This IC can provide following types of output voltage: step down, step up, and inverte • Wide supply voltage range: 3.6 V to 18 V\n• Low current consumption: 1.3 mA typical\n• Wide oscillation frequency range: 1 kHz to 500 kHz\n• On-chip timer latch short protection circuit\n• On-chip under voltage lockout protection\n• On-chip reference voltage: 1.28 V\n• Variable dead time provides ;

SWITCHING REGULATOR CONTROLLER

文件：1.0786 Mbytes Page：30 Pages

SWITCHING REGULATOR CONTROLLER

文件：1.0786 Mbytes Page：30 Pages

SWITCHING REGULATOR CONTROLLER

文件：1.0786 Mbytes Page：30 Pages

SWITCHING REGULATOR CONTROLLER

文件：1.0786 Mbytes Page：30 Pages

SWITCHING REGULATOR CONTROLLER

Dual Stepper Motor Driver

Description The PBL 3775/1 is a switch-mode (chopper), constant-current driver IC with two channels, one for each winding of a two-phase stepper motor. The circuit is similar to Ericsson´s PBL 3773/1. While several of Ericsson´s dual stepper motor drivers are optimized for micro-stepping applicat

Dual Stepper Motor Driver

Description The PBL 3775/1 is a switch-mode (chopper), constant-current driver IC with two channels, one for each winding of a two-phase stepper motor. The circuit is similar to Ericsson´s PBL 3773/1. While several of Ericsson´s dual stepper motor drivers are optimized for micro-stepping applicat

Dual-Rate Fibre Channel Repeaters

文件：220.59 Kbytes Page：9 Pages

DUAL STEPPER MOTOR DRIVER

文件：184.29 Kbytes Page：10 Pages