Dual 10-bit bus interface latch 3-State

DESCRIPTION The MB2841 Bus interface register is designed to provide extra data width for wider data/address paths of buses carrying parity. The MB2841 consists of two sets of ten D-type latches with 3-State outputs. The flip-flops appear transparent to the data when Latch Enable (nLE) is High.

Dual 10-bit bus interface latch 3-State

DESCRIPTION The MB2841 Bus interface register is designed to provide extra data width for wider data/address paths of buses carrying parity. The MB2841 consists of two sets of ten D-type latches with 3-State outputs. The flip-flops appear transparent to the data when Latch Enable (nLE) is High.

Dual-Loop 50 Mbps.2.7 Gbps Laser Diode Driver

GENERAL DESCRIPTION The ADN2841 uses a unique control algorithm to control both average power and extinction ratio of the laser diode (LD) after initial factory set up. External component count and PCB area are low as both power and extinction ratio control are fully integrated. Programmable alar

286 MHz surface mount bandpass filter

文件：371.81 Kbytes Page：2 Pages

Thick Panel Snap Bushings

文件：120.34 Kbytes Page：1 Pages

64 x 4 BITS FIRST-IN FIRST-OUT MEMORIES

文件：407.38 Kbytes Page：6 Pages

64 x 4 BITS FIRST-IN FIRST-OUT MEMORIES

文件：407.38 Kbytes Page：6 Pages