3V to 5.5V, 1.5Mbps RS-232 Receivers in SOT23-5

General Description The MAX3180–MAX3183 are single RS-232 receivers in a SOT23-5 package for space- and cost-constrained applications requiring minimal RS-232 communications. These devices minimize power and heat dissipation by consuming only 0.5µA supply current from a +3.0V to +5.5V supply volt

+3V至+5.5V、1.5Mbps RS-232接收器，SOT23-5封装

MAX3180–MAX3183是单通道RS-232接收器，采用SOT23-5封装，适用于需要少量RS-232通信且空间和成本受限的应用。这些器件在+3.0V至+5.5V电源电压下的电源电流消耗仅为0.5µA，充分降低了功耗和散热要求。它们可确保数据速率达到1.5Mbps，实现真正的RS-232性能。\n\n MAX3180/MAX3182具有由低电平有效EN逻辑输入控制的三态TTL/CMOS接收器输出。MAX3181/MAX3183具有低电平有效INVALID输出，用于指示接收器输入端的有效RS-232信号，适用于需要自动系统唤醒功能的应用。MAX3180/MAX3181接收器具有标 • 小型SOT23-5封装\n\n• 电源电流：0.5µA\n\n• 支持1.5Mbps数据速率\n\n• 符合EIA/TIA-232和V.28/V.24规范，低至VCC = +3.0V\n\n• 低电平有效INVALID输出指示接收器输入端的有效RS-232信号(MAX3181/MAX3183)\n\n• 三态TTL/CMOS接收器输出(MAX3180/MAX3182)\n\n• 同相RS-232输出(MAX3182/MAX3183);

±15kV ESD保护、0.5µA、+3V至+5.5V、1.5Mbps RS-232接收器，SOT23-5封装

MAX3180E-MAX3183E单通道RS-232接收器采用SOT23-5封装，专为需要少量RS-232通信且空间和成本受限的应用而设计。接收器输入使用IEC 1000-4-2气隙放电受到±15kV的保护，使用IEC 1000-4-2接触放电受到±8kV的保护，并根据人体模型受到±15kV的保护，确保符合国际标准。\n\n 这些器件在+3.0V至+5.5V电源下的电源电流消耗仅为0.5µA，充分降低了功耗和散热要求，并确保达到1.5Mbps数据速率，实现真正的RS-232性能。MAX3180E/MAX3182E具有由低电平有效EN逻辑输入控制的三态TTL/CMOS接收器输出。MAX • 小型SOT23-5封装\n\n• RS-232输入受到ESD保护\n• ±15kV——人体模型\n\n• ±8kV——IEC 1000-4-2，接触放电\n\n• ±15kV——IEC 1000-4-2，气隙放电\n\n\n\n\n• 电源电流：0.5µA\n\n• 支持1.5Mbps数据速率\n\n• 符合EIA/TIA-232和V.28/V.24规范，低至VCC = +3.0V\n\n• 低电平有效INVALID输出指示接收器输入端的有效RS-232信号(MAX3181E/MAX3183E)\n\n• 三态TTL/CMOS接收器输出(MAX3180E/MAX3182E)\n\n• 同相;

-15kV ESD-Protected, 0.5UA, 3V to 5.5V, 1.5Mbps RS-232 Receivers in SOT23-5

General Description The MAX3180E–MAX3183E single RS-232 receivers in a SOT23-5 package are designed for space- and cost constrained applications requiring minimal RS-232 communications. The receiver inputs are protected to ±15kV using IEC 1000-4-2 Air-Gap Discharge, to ±8kV using IEC 1000-4-2 Con

-15kV ESD-Protected, 0.5UA, 3V to 5.5V, 1.5Mbps RS-232 Receivers in SOT23-5

General Description The MAX3180E–MAX3183E single RS-232 receivers in a SOT23-5 package are designed for space- and cost constrained applications requiring minimal RS-232 communications. The receiver inputs are protected to ±15kV using IEC 1000-4-2 Air-Gap Discharge, to ±8kV using IEC 1000-4-2 Con

3V to 5.5V, 1.5Mbps RS-232 Receivers in SOT23-5

General Description The MAX3180–MAX3183 are single RS-232 receivers in a SOT23-5 package for space- and cost-constrained applications requiring minimal RS-232 communications. These devices minimize power and heat dissipation by consuming only 0.5µA supply current from a +3.0V to +5.5V supply volt

3V to 5.5V, 1.5Mbps RS-232 Receivers in SOT23-5

General Description The MAX3180–MAX3183 are single RS-232 receivers in a SOT23-5 package for space- and cost-constrained applications requiring minimal RS-232 communications. These devices minimize power and heat dissipation by consuming only 0.5µA supply current from a +3.0V to +5.5V supply volt

封装/外壳：SC-74A，SOT-753 包装：卷带（TR）剪切带（CT）Digi-Reel® 得捷定制卷带 描述：IC RECEIVER 0/1 SOT23-5 集成电路（IC） 驱动器，接收器，收发器

封装/外壳：SC-74A，SOT-753 包装：卷带（TR） 描述：IC RECEIVER 0/1 SOT23-5 集成电路（IC） 驱动器，接收器，收发器

5-Bit or 6-Bit Programmable 2-,3-,4-Phase Synchronous Buck Controller

GENERAL DESCRIPTION The ADP3181 is a highly efficient multiphase synchronous buck-switching regulator controller optimized for converting a 12 V main supply into the core supply voltage required by high performance Intel processors. It uses an internal 6-bit DAC to read a voltage identification (

Optoisolators (Photocouplers)

Overview CNC7S101 is an AC input compatible optoisolator in which two GaAs high output infrared light emitting diode chips are connected in reverse parallel as light emitting elements, and opitically are connected to a high sensitivity Si phototransistor chip as a light detecting element in