1.2V to 5.5V, 짹15kV ESD-Protected, 0.1UA, 35Mbps, 8-Channel Level Translators

General Description The MAX3000E/MAX3001E/MAX3002–MAX3012 8-channel level translators provide the level shifting necessary to allow data transfer in a multivoltage system. Externally applied voltages, VCC and VL, set the logic levels on either side of the device. Logic signals present on the VL s

+1.2V至+5.5V、±15kV ESD保护、0.1µA、35Mbps、8通道电平转换器

MAX3000E/MAX3001E/MAX3002–MAX3012 8通道电平转换器能够为多电压系统的数据传输提供必要的电平转换。外接电压VCC和VL分别设置转换器两侧的逻辑电平。器件VL一侧的逻辑信号在VCC一侧呈现为较高电压的逻辑信号，反之亦然。\n MAX3000E/MAX3001E/MAX3002/MAX3003利用特殊的设计结构实现双向数据传输，无需方向引脚。\n MAX3000E/MAX3001E/MAX3002/MAX3004–MAX3012有一个EN输入端，当EN为低电平时VCC和VL的电源电流减小到2µA以内。MAX3000E/MAX3001E在VCC一侧的I/O具有±15k \n• 可保证数据传输率为 \n• 230kbps (MAX3000E) \n• 4Mbps (MAX3001E) \n• 20Mbps (MAX3002–MAX3012) \n• 无需采用方向引脚即可实现双向电平转换(MAX3000E/MAX3001E/MAX3002/MAX3003) \n• 单向电平转换(MAX3004–MAX3012) \n• VL电压可低至+1.2V \n• VCC侧I/O口具有±15kV ESD保护(MAX3000E/MAX3001E) \n• 在关断状态下具有0.1µA的超低电源电流 \n• 低静态电流(< 10µA) \n• UCSP、TQFN和TSSOP封装;

优化用于可穿戴健康设备的脉搏血氧仪和心率AFE

MAX30110为完备的光学脉搏血氧和心率检测集成模拟前端。MAX30110具有高分辨率、光学读数信号处理通道，内置环境光抵消，以及高电流LED驱动器DAC，形成完备的光学读数信号链。使用外部LED和光二极管，MAX30110为手腕应用提供极低功耗、最高性能的心率检测方案。\n\n MAX30110工作在1.8V主电源电压，使用独立的3.1V至5.25V LED驱动器电源。器件支持标准SPI兼容接口，以及通过软件实现关断模式，待机电流接近于零，允许电源时刻保持供电。\n\n • 反射或透射心率、心率变异或SpO2监测\n• 发送部分\n• 2个8位LED电流DAC\n• 4个电流范围：50mA、100mA、150mA、200mA\n• 低噪声电流源，支持较高峰值发射至接收动态范围\n• 160mV低压差，支持由可充电锂电池直接驱动\n• 高输出阻抗和高电源抑制，支持非稳压电源或升压电源直接驱动\n\n\n• 接收部分\n• 19位光学ADC通路，支持最低血流灌注情况\n• 25pA真有效值较低输入参考噪声，最大程度降低大多数情况下的LED功耗\n• 200μA高环境光输入范围，支持在最不利照明条件下提取HRM信号\n• 内置前端和后端环境光抵消，提高抑制能力，消除;

优化用于可穿戴健康设备的脉搏血氧仪和心率AFE

MAX30112为完备的光学脉搏血氧和心率检测集成模拟前端。MAX30112具有高分辨率、光学读数信号处理通道，内置环境光抵消，以及高电流LED驱动器DAC，形成完备的光学读数信号链。使用外部LED和光二极管，MAX30112为手腕应用提供极低功耗、最高性能的心率检测方案。\n\n MAX30112工作在1.8V主电源电压，使用独立的3.1V至5.25V LED驱动器电源。器件支持标准I2C兼容接口，以及通过软件实现关断模式，待机电流接近于零，允许电源时刻保持供电。\n\n • 反射或透射心率、心率变异或SpO2监测\n• 发送部分\n• 2个8位LED电流DAC\n• 4个电流范围：50mA、100mA、150mA、200mA\n• 低噪声电流源，支持较高峰值发射至接收动态范围 \n• 160mV低压差，支持由可充电锂电池直接驱动 \n• 高输出阻抗和高电源抑制，支持非稳压电源或升压电源直接驱动\n\n\n• 接收部分\n• 19位光学ADC通路，支持最低血流灌注情况 \n• 25pA真有效值较低输入参考噪声，最大程度降低大多数情况下的LED功耗\n• 200μA高环境光输入范围，支持在最不利照明条件下提取HRM信号\n• 内置前端和后端环境光抵消，提高抑制能力;

1.2V to 5.5V, 짹15kV ESD-Protected, 0.1UA, 35Mbps, 8-Channel Level Translators

General Description The MAX3000E/MAX3001E/MAX3002–MAX3012 8-channel level translators provide the level shifting necessary to allow data transfer in a multivoltage system. Externally applied voltages, VCC and VL, set the logic levels on either side of the device. Logic signals present on the VL s

1.2V to 5.5V, 짹15kV ESD-Protected, 0.1UA, 35Mbps, 8-Channel Level Translators

General Description The MAX3000E/MAX3001E/MAX3002–MAX3012 8-channel level translators provide the level shifting necessary to allow data transfer in a multivoltage system. Externally applied voltages, VCC and VL, set the logic levels on either side of the device. Logic signals present on the VL s

Quick Evaluation of the MAX30110

文件：6.25492 Mbytes Page：27 Pages

Optimized Pulse-Oximeter and Heart Rate AFE forWearable Health

文件：711.24 Kbytes Page：37 Pages

Quick Evaluation of the MAX30110

文件：6.25492 Mbytes Page：27 Pages

MAX30110 Evaluation Kit

文件：6.25492 Mbytes Page：27 Pages

包装：散装 描述：IC SENSOR OXIMETER/HEARTRATE AFE 传感器，变送器 专用传感器

包装：盒 描述：INTEGRATED BIOSENSOR FOR MOBILE 传感器，变送器 专用传感器

Quick Evaluation of the MAX30110

文件：6.25492 Mbytes Page：27 Pages

Wrist-Worn Wearable Devices

文件：707.05 Kbytes Page：40 Pages

1.2V to 5.5V, ±15kV ESD-Protected, 0.1μA,35Mbps, 8-Channel Level Translators

文件：216.57 Kbytes Page：25 Pages

1.2V to 5.5V, ±15kV ESD-Protected, 0.1μA,35Mbps, 8-Channel Level Translators

文件：216.57 Kbytes Page：25 Pages

Optocoupler with Phototriac Output

Description The K3010P(G) series consists of a phototransistor optically coupled to a gallium arsenide infrared-emitting diode in a 6-lead plastic dual inline package. The elements are mounted on one leadframe using a coplanar technique, providing a fixed distance between input and output for h

Optocoupler with Phototriac Output

Description The K3010P(G) series consists of a phototransistor optically coupled to a gallium arsenide infrared-emitting diode in a 6-lead plastic dual inline package. The elements are mounted on one leadframe using a coplanar technique, providing a fixed distance between input and output for h

Optocoupler with Phototriac Output

Description The K3010P(G) series consists of a phototransistor optically coupled to a gallium arsenide infrared-emitting diode in a 6-lead plastic dual inline package. The elements are mounted on one leadframe using a coplanar technique, providing a fixed distance between input and output for h

6-Pin DIP Random-Phase Optoisolators Triac Driver Output

6-Pin DIP Random-Phase Optoisolators Triac Driver Output (250 Volts Peak) The MOC3010 Series consists of gallium arsenide infrared emitting diodes, optically coupled to silicon bilateral switch and are designed for applications requiring isolated triac triggering, low–current isolated ac switchin

Discrete LED Indicators

Features: • All Plastic Mold Type: NTE3007 (Diffused Red, Gallium Arsenide Phosphide Red) NTE3008 (Diffused Bright Red, Gallium Phosphide on Gallium Phosphide Red) NTE3009 (Diffused Orange, Gallium Arsenide Phosphide on Gallium Phosphide Orange) NTE3010 (Diffused Green,