轨至轨输出、215MHz、1.1nV/√Hz 运算放大器 / SAR ADC 驱动器

LT®6236 / LT6237 / LT6238 是单路 / 双路 / 四路低噪声、轨至轨输出运算放大器，具有 1.1nV/√Hz 的输入参考噪声电压密度，且每个放大器仅吸收 3.5mA 的电源电流。这些放大器将非常低的噪声和电源电流与一个 215MHz 的增益带宽乘积和一个 70V/μs 的转换速率组合在一起。低噪声、快速稳定时间和低失调电压使该放大器非常适合驱动低噪声、高速 SAR ADC。LT6236 具有一种停机功能，可用于把电源电流减小至 10μA 以下。\n\n 该放大器系列具有一个可在任一电源轨的 50mV 之内摆动的输出，旨在较大限度地拓宽低电源应用中的信号动态范围 • 低噪声：1.1nV/√Hz\n\n• 低电源电流：每个放大器的最大电源电流为 3.5mA\n\n• 低失调电压：350μV (最大值)\n\n• 快速稳定时间：570ns (至 18 位、2VP-P 输出)\n\n• 低失真：在 2kHz 时 THD = –116.8dB\n\n• 宽电源范围：3V 至 12.6V\n\n• 轨至轨输出摆幅\n\n• 215MHz 增益带宽乘积\n\n• 规定温度范围：–40°C 至 125°C\n\n• LT6236 停机电流至 10μA (最大值)\n\n• LT6236 采用扁平 (高度仅 1mm) ThinSOT™ 封装\n\n• 双通道器件 LT;

Rail-to-Rail Output 215MHz, 1.1nV/?숰z Op Amp/SAR ADC Driver

文件：571.59 Kbytes Page：24 Pages

Octal, 16-Bit, 200ksps Differential SoftSpan ADC with Wide Input Common Mode Range

文件：2.01901 Mbytes Page：40 Pages

14-Bit, 4.5Msps Serial Sampling ADC in TSOT

文件：984.19 Kbytes Page：20 Pages

18-Bit, 1Msps, 8-Channel SAR ADC with 100dB SNR

文件：1.92782 Mbytes Page：50 Pages

16-Bit, 1Msps, 8-Channel SAR ADC with 96dB SNR

文件：2.75106 Mbytes Page：52 Pages

Octal, 18-Bit, 200ksps Differential SoftSpan ADC with Wide Input Common Mode Range

文件：1.88721 Mbytes Page：40 Pages

18-Bit, 5Msps SAR ADC

文件：1.09775 Mbytes Page：22 Pages

14-Bit, 500ksps Serial Sampling ADC in TSOT

文件：626.01 Kbytes Page：22 Pages

12-Bit, 5Msps Serial Sampling ADC in TSOT

文件：911.87 Kbytes Page：20 Pages

16-Bit, 500ksps, 8-Channel SAR ADC with 96dB SNR

文件：2.80231 Mbytes Page：50 Pages

12-Bit, 500ksps Serial Sampling ADC in TSOT

文件：513.1 Kbytes Page：22 Pages

Rail-to-Rail Output 215MHz, 1.1nV/Hz Op Amp/SAR ADC Driver

文件：1.56796 Mbytes Page：26 Pages

High-Efficiency, Quad-Output, Main Power Supply Controllers for Notebook Computers

High-Efficiency, Quad-Output, Main Power Supply Controllers for Notebook Computers The ISL6236 dual step-down, switch-mode power-supply (SMPS) controller generates logic-supply voltages in battery-powered systems. The ISL6236 include two pulse-width modulation (PWM) controllers, 5V/3.3V an

Powerblock Module

Description: The NTE6236 uses 2 high voltage power diodes in series and the semiconductors are electrically isolated from the metal base, allowing common heatsinks and compact assemblies to be built. This device is intended for general purpose applications such as battery chargers, welders and

IR Receiver Modules for Remote Control Systems

DESCRIPTION The TSOP6 series are miniaturized SMD IR receiver modules for infrared remote control systems. A PIN diode and a preamplifier are assembled on a leadframe, the epoxy package contains an IR filter. The demodulated output signal can be directly connected to a microprocessor for deco

H-bridge drivers (36V max.)

文件：389.87 Kbytes Page：17 Pages

Smart Octal Low-Side Switch

文件：526.51 Kbytes Page：15 Pages