180MHz, 1mA Power Efficient Rail-to-Rail I/O Op Amps

FEATURES APPLICATIONS n Gain Bandwidth Product: 180MHz n –3dB Frequency (AV = 1): 120MHz n Low Quiescent Current: 1mA Max n High Slew Rate: 90V/μs n Input Common Mode Range Includes Both Rails n Output Swings Rail-to-Rail n Low Broadband Voltage Noise: 4.2nV/√Hz n Power-Down Mode: 42μA n

轨至轨输入和输出、1.9nV/√Hz 超低噪声、低功率、100MHz 四路运算放大器

LT®6202 / LT6203 / LT6204 是低噪声、轨至轨输入和输出、整体增益稳定的单 / 双 / 四运算放大器，它们具有 1.9nV/√Hz 的噪声电压，每个放大器仅吸收 2.5mA 的供电电流。这些放大器把非常低噪声和供电电流与 100MHz 的增益带宽乘积、25V/us 的转换速率结合在一起，并针对低电源电压信号调节系统进行了优化。\n\n 这些放大器能在 2.5V 至 12.6V 的电源电压条件下维持自身的性能，并针对 3V、5V 和 ±5V 电源拟订了技术规格。在 1MHz 条件下，谐波失真低于 -80dBc，使得这些放大器成为低功率数据采集系统的恰当之选。\n\ • 低噪声电压：1.9nV/√Hz (100kHz) \n\n• 低供电电流：每放大器 3mA (最大值) \n\n• 增益带宽乘积：100MHz \n\n• 两个 LT6203 于纤巧的 DFN 封装内 \n\n• 低失真：在 1MHz 条件下为 -80dB \n\n• 低失调电压：500µV (最大值) \n\n• 宽电源电压范围：2.5V 至 12.6V \n\n• 输入共模范围包括正负电源电压 \n\n• 轨至轨输出摆动 \n\n• 共模抑制比：90dB (典型值) \n\n• 整体增益稳定 \n\n• 低噪声电流：1.1pA/√Hz \n\n• 输出电流：30mA (最小值) \n\;

1nV/?숰z 420MHz GBW, 180V/關s, Low Distortion Rail-to-Rail Output Op Amps

文件：2.2649 Mbytes Page：28 Pages

Rail-to-Rail Input and Output, Ultralow 1.9n Root Hz Noise, Low Power Op Amps

文件：591.27 Kbytes Page：24 Pages

1.3GHz Low Noise, Low Distortion Differential ADC Driver for 140MHz IF

文件：223.95 Kbytes Page：16 Pages

2GHz, 3.5mA Gain of 7 Stable Rail-to-Rail I/O Dual Op Amp

文件：1.03324 Mbytes Page：18 Pages

Single/Dual Operational Amplifiers

文件：380.48 Kbytes Page：16 Pages

2.4GHz Low Noise, Low Distortion Differential ADC Driver for 300MHz IF

文件：213.49 Kbytes Page：16 Pages

Single/Dual/Quad 100MHz, Rail-to-Rail Input and Output

文件：1.61811 Mbytes Page：28 Pages

丝印代码：6204；Rail-to-Rail Input and Output, Ultralow 1.9n Root Hz Noise, Low Power Op Amps

文件：591.27 Kbytes Page：24 Pages

Rail-to-Rail Input and Output, Ultralow 1.9n Root Hz Noise, Low Power Op Amps

文件：591.27 Kbytes Page：24 Pages

丝印代码：6204I；Rail-to-Rail Input and Output, Ultralow 1.9n Root Hz Noise, Low Power Op Amps

文件：591.27 Kbytes Page：24 Pages

Rail-to-Rail Input and Output, Ultralow 1.9n Root Hz Noise, Low Power Op Amps

文件：591.27 Kbytes Page：24 Pages

Laser Driver Oscillator

General Description The EL6204C is a push-pull oscillator used to reduce laser noise. It uses the standard interface to existing ROM controllers. The frequency and amplitude are each set with a separate resistor connected to ground. The tiny package and harmonic reduction allow the part to be pla

Laser Driver Oscillator

General Description The EL6204C is a push-pull oscillator used to reduce laser noise. It uses the standard interface to existing ROM controllers. The frequency and amplitude are each set with a separate resistor connected to ground. The tiny package and harmonic reduction allow the part to be pla

DMOS DUAL FULL BRIDGE DRIVER

DESCRIPTION The L6204 is a dual full bridge driver for motor control applications realized in BCD technology which combines isolated DMOS power transistors with CMOS and Bipolar circuits on the same chip. By using mixed technology it has been possible to optimize the logic circuitry and the power

PIN DIODE

DESCRIPTION These series of PIN diodes are designed for applications requiring small package size and moderate average power handling capability. The low capacitance of the UM6000 and UM6600 allows them to be used as series switching elements to 1 GHz. The low resistance of the UM6200 is useful

Voltage Regulators

文件：25.85 Kbytes Page：1 Pages