42VIN Micropower No-Opto Isolated Flyback Converter with 65V/3.6A Switch

DESCRIPTION The LT®8302/LT8302-3 is a monolithic micropower isolated flyback converter. By sampling the isolated output voltage directly from the primary-side flyback waveform, the part requires no third winding or opto-isolator for regulation. The output voltage is programmed with two external r

42VIN Micropower No-Opto Isolated Flyback Converter with 65V/1.2A Switch

DESCRIPTION The LT®8301 is a micropower isolated flyback converter. By sampling the isolated output voltage directly from the primary-side flyback waveform, the part requires no third winding or opto-isolator for regulation. The output voltage is programmed with a single external resistor. Intern

100VIN Micropower Isolated Flyback Converter with 150V/260mA Switch

DESCRIPTION The LT®8300 is a micropower high voltage isolated flyback converter. By sampling the isolated output voltage directly from the primary-side flyback waveform, the part requires no third winding or opto-isolator for regulation. The output voltage is programmed with a single external res

Boost, Flyback, SEPIC and Inverting Controller

FEATURES n Wide Input Voltage Range: 2.9V to 40V n Positive or Negative Output Voltage Programming with a Single Feedback Pin n Current Mode Control Provides Excellent Transient Response n Programmable Operating Frequency (100kHz to 1MHz) with One External Resistor n Synchronizable to an E

宽输入电压范围升压 / SEPIC / 负输出控制器

LT®3759 是一款宽输入范围、电流模式、DC/DC 控制器，该器件能够利用单个反馈引脚调节正输出电压或负输出电压。它可以被配置为一个升压、SEPIC 或负输出转换器。\n\n LT3759 可驱动一个低端外部 N 沟道功率 MOSFET。一个内部 LDO 稳压器从 VIN 或 DRIVE 吸取功率，以为栅极驱动器提供一个高达 4.75V 的电源。固定频率、电流模式架构在一个很宽的电源电压和输出电压范围内实现了稳定的操作。LT3759 的工作频率可利用一个外部电阻器来设定 (可设置范围为 100kHz 至 1MHz)，或者采用 SYNC 引脚来使其同步至一个外部时钟。\n\n • 宽 VIN 范围：1.6V 至 42V\n\n• 利用单个反馈引脚来设置正或负输出电压\n\n• PGOOD 输出电压状态报告\n\n• 准确的 50mV 检测门限电压\n\n• 可编程软起动\n\n• 可利用一个外部电阻器来设置工作频率 (100kHz 至 1MHz)\n\n• 可同步至一个外部时钟\n\n• 低停机电流：<1μA\n\n• INTVCC 稳压器从 VIN 或 DRIVE 供电\n\n• 具迟滞的可编程输入欠压闭锁;

Wide Input Voltage Range Boost/SEPIC/Inverting Converter with 6A, 40V Switch

文件：423.21 Kbytes Page：24 Pages

No RSENSE Current Mode Boost DC/DC Controller

文件：302.67 Kbytes Page：20 Pages

Wide Input Voltage Range Boost/SEPIC/Inverting Controller

文件：445.27 Kbytes Page：32 Pages

Wide Input Voltage Range

文件：514.289 Kbytes Page：32 Pages

100VIN Micropower Isolated Flyback Converter with 150V/260mA Switch

文件：313.4 Kbytes Page：24 Pages

Synchronous SEPIC/ Inverting/Boost Controller with Output Current Control

文件：646.79 Kbytes Page：44 Pages

60V 2MHz Low-IQ Boost, SEPIC and Flyback Controller

文件：2.88992 Mbytes Page：34 Pages

Wide Input Voltage Range Boost/SEPIC/Inverting Controller

文件：445.27 Kbytes Page：32 Pages

Wide Input Voltage Range Boost/SEPIC/Inverting Controller

文件：445.27 Kbytes Page：32 Pages

Switching Regulator Controller (Switchable between push-pull and single-end functions)

DESCRIPTION The MB3759 is a control IC for constant-frequency pulse width modulated switching regulators. The IC contains most of the functions required for switching regulator control circuits. This reduces both the component count and assembly work. FEATURES • Drives a 20

Switching Regulator Controller (Switchable between push-pull and single-end functions)

DESCRIPTION The MB3759 is a control IC for constant-frequency pulse width modulated switching regulators. The IC contains most of the functions required for switching regulator control circuits. This reduces both the component count and assembly work. FEATURES • Drives a 20

Switching Regulator Controller (Switchable between push-pull and single-end functions)

DESCRIPTION The MB3759 is a control IC for constant-frequency pulse width modulated switching regulators. The IC contains most of the functions required for switching regulator control circuits. This reduces both the component count and assembly work. FEATURES • Drives a 20

Switching Regulator Controller (Switchable between push-pull and single-end functions)

文件：269.72 Kbytes Page：28 Pages

IC for CMOS System Reset Monolithic IC

文件：66.7 Kbytes Page：10 Pages