High Temperature 1.0A, 35MHz Current Feedback Amplifier

FEATURES - Extreme High Temperature Operation: –40°C to 175°C - 1.0A Minimum Output Drive Current - 35MHz Bandwidth, AV = 2, RL = 10 - 900V/μs Slew Rate, AV = 2, RL = 10 - High Input Impedance: 10M - Wide Supply Range: ±5V to ±15V - Shutdown Mode: IS

1.1A, 35MHz Current Feedback Amplifier

FEATURES APPLICATIONS nn 1.1A Minimum Output Drive Current nn 35MHz Bandwidth, AV = 2, RL = 10Ω nn 900V/μs Slew Rate, AV = 2, RL = 10Ω nn High Input Impedance: 10MΩ nn Wide Supply Range: ±5V to ±15V (TO-220 and DD Packages) nn Enhanced θJA SO-16 Package for ±5V Operation nn Shutdown Mode:

1MHz/500kHz Continuous Time, Low Noise, Lowpass Elliptic Filter

FEATURES n 5th Order, 1MHz Elliptic Filter in SO-8 Package n Pin Selectable 1MHz/500kHz Cutoff Frequency n Signal-to-Noise Ratio (SNR): 75dB n Signal-to-Noise Ratio with – 63dB THD: 69dB n Passband Ripple (fCUTOFF = 1MHz): ±0.3dB n Stopband Attenuation Better Than 60dB n No External Compone

50MHz、800V/μs 运算放大器

LT®1360 是一款高速、非常高转换速率运算放大器，具备卓越的 DC 性能。与具有相似带宽的同类器件相比，LT1360 拥有减低的电源电流、较低的输入失调电压、较低的输入偏置电流和较高 DC 增益。电路拓扑是一个具有电流反馈放大器之转换特性的电压反馈放大器。该放大器是一个具出色稳定特性的单增益级，从而使这个电路成为数据采集系统的理想选择。输出能够采用 ±15V电源把一个 500Ω 负载驱动至 ±13V，和采用 ±5V 电源把一个 150Ω 负载驱动至 ±3.2V。另外，这款放大器还能驱动任何容性负载，因而使其适用于缓冲器或电缆驱动器应用。\n\n LT1360 隶属于一个快速、高性 • 50MHz 增益带宽\n\n• 800V/μs 转换速率\n\n• 5mA 最大电源电流\n\n• 9nV/√Hz 输入噪声电压\n\n• 具稳定的单位增益\n\n• C-Load™ 运放可驱动全容性负载\n\n• 1mV 最大输入失调电压\n\n• 1μA 最大输入偏置电流\n\n• 250nA 最大输入失调电流\n\n• 驱动 500Ω 负载时的最小输出摆幅为 ±13V\n\n• 驱动 150Ω 负载时的最小输出摆幅为 ±3.2V\n\n• 4.5V/mV 最小 DC 增益，RL = 1k\n\n• 60ns 稳定时间至 0.1%，10V 阶跃\n\n• 0.2% 差分;

50MHz, 800V/s Op Amp

文件：229.03 Kbytes Page：16 Pages

90MHz, 2200V/關s 30V Low Power Op Amps

文件：1.70083 Mbytes Page：20 Pages

50MHz, 800V/us Op Amp

文件：263.46 Kbytes Page：16 Pages

50MHz, 800V/s Op Amp

文件：229.03 Kbytes Page：16 Pages

50MHz, 800V/us Op Amp

文件：263.46 Kbytes Page：16 Pages

50MHz, 800V/us Op Amp

文件：263.46 Kbytes Page：16 Pages

READ/WRITE AMPLIFIER FOR FLOPPY DISK DRIVE WITH BUILT-IN FILTER

Description The CXA1360Q is designed for FDD (Floppy Disk Drive) use. This IC combines such functions as Read, Write, Erase and Supply voltage detection circuits in a single chip.

VARIABLE CAPACITANCE DIODE

DESCRIPTION The KV1360NT variable capacitance diode was specially developed for use as FM tuning elements in car radios, radio cassettes, and other consumer radios. The KV1360NT uses a special process to provide a very high capacitance ratio in low voltage operation. The KV1360NT is available i

Low-voltage low-power stereo audio ADC

文件：84.7 Kbytes Page：16 Pages

Low-voltage low-power stereo audio ADC

文件：84.7 Kbytes Page：16 Pages