Low Dropout Regulator with Delayed Reset

文件：404.08 Kbytes Page：10 Pages

Low Dropout Regulator with Delayed Reset

Low Dropout Regulator with Delayed Reset

General Description\nThe LM2926 is a 5V, 500 mA, low dropout regulator with delayed reset. The microprocessor reset flag is set low by thermal shutdown, short circuits, overvoltage conditions, dropout, and power-up. After the fault condition is corrected, the reset flag remains low for a delay time 5% output accuracy over entire operating range\nDropout voltage typically 350 mV at 500 mA output\nExternally programmed reset delay\nShort circuit proof\nReverse battery proof\nThermally protected\nLM2926 is pin-for-pin compatible with the LM2925\nP+ Product Enhancement testedApplications\nBatt;

Low Dropout Regulator with Delayed Reset

文件：319.87 Kbytes Page：9 Pages

Low Dropout Regulator with Delayed Reset

文件：404.08 Kbytes Page：10 Pages

UHF DUAL CONVERSION TRANSCEIVER

Product Description The RF2926 is a monolithic integrated circuit intended for use as a low cost FM transceiver. The device is provided in 48-lead plastic TQFP packaging and is designed to provide a dual conversion, half-duplex transceiver. The chip is intended for linear (AM, FM) or digital (ASK

THREE-TERMINAL LOW DROPOUT VOLTAGE REGULATOR

THREE-TERMINAL LOW DROPOUT VOLTAGE REGULATOR DESCRIPTION The µPC2918, 2925 and 2926 are three-terminal low dropout voltage regulators with the 1-A output. The µPC2918 outputs 1.8 V, the µPC2925 outputs 2.5 V and the µPC2926 outputs 2.6 V. Since these regulators use a PNP transistor for the