Current Transducer LB 1000-SI/SP2

For the electronic measurement of currents : DC, AC, pulsed , with a galvanic isolation between the primary circuit (high power) and the secondary circuit (electronic circuit). Features • Closed loop (compensated) current transducer using the Hall effect • Insulated plastic case recognized ac

Current Transducer

文件：40.9 Kbytes Page：3 Pages

Current Transducer LB 1000-SI/SP2

Current Transducer LB 1000-SI/SP2

For the electronic measurement of currents : DC, AC, pulsed , with a galvanic isolation between the primary circuit (high power) and the secondary circuit (electronic circuit). Features • Closed loop (compensated) current transducer using the Hall effect • Insulated plastic case recognized ac

Current Transducer LB 1000-SI/SP2

For the electronic measurement of currents : DC, AC, pulsed , with a galvanic isolation between the primary circuit (high power) and the secondary circuit (electronic circuit). Features • Closed loop (compensated) current transducer using the Hall effect • Insulated plastic case recognized ac

SUPERFAST RECOVERY RECTIFIERS(VOLTAGE: 50 to 400 Volts CURRENT: 10.0 Amperes)

VOLTAGE 50 to 600 Volts CURRENT 10 Amperes FEATURES • Plastic package has Underwriters Laboratory Flammability Classification 94V-O. Flame Retardant Epoxy Molding Compound. • Exceeds environmental standards of MIL-S-19500/228 • Low power loss, high efficiency. • Low forwrd voltge, hig

SUPERFAST RECOVERY RECTIFIERS(VOLTAGE: 50 to 400 Volts CURRENT: 10.0 Amperes)

VOLTAGE 50 to 600 Volts CURRENT 10 Amperes FEATURES • Plastic package has Underwriters Laboratory Flammability Classification 94V-O. Flame Retardant Epoxy Molding Compound. • Exceeds environmental standards of MIL-S-19500/228 • Low power loss, high efficiency. • Low forwrd voltge, hig

Silicon planar type

Silicon planar type For stabilization of power supply ■ Features • High reliability, achieved by the combination the planar type and the glass seal • Large power dissipation: PD = 500 mW (With a printed-circuit board) • Wide voltage range: VZ = 2.0 V to 39 V • Easy-to-use because of the fine

Medium-Power Complementary Silicon Transistors

Medium-Power Complementary Silicon Transistors . . . for use as output devices in complementary general purpose amplifier applications. • High DC Current Gain — hFE = 6000 (Typ) @ IC = 3.0 Adc • Monolithic Construction with Built–in Base–Emitter Shunt Resistors

MICROMACHINED ACCELEROMETER

The XMMA series of silicon capacitive, micromachined accelerometers features; signal conditioning, a 4–pole low pass filter and temperature compensation. Zero–g offset full scale span and filter cut–off are factory set and require no external devices. A full system self–test capability verifies sy