Additional Application Notes

1: It is possible that during transit or final assmely the relay could change state. Therefore, it is recommended that all relays be set to

the desired state via a power supply.

2: In order to maintain an Open or Closed state of the relay, the coil voltage should reach the rated voltage. The pulse width should

be 50ms minimum to ensure a proper change of state. DO NOT energize both T1 and T2 at the same time on a Dual Coil or energize

the coil longer than 1 minute (damage to the coil could occur).

3: For assistance with wave solder process settings, please contact KG Technologies.

4: For defineitions of terms used in this data sheet, see glossary at: https://kgtechnologies.net/pages/data-sheet-glossary