The ISLA118P50 is a low-power, high-performance, 500MSPS

analog-to-digital converter designed with Intersil’s proprietary

FemtoCharge™ technology on a standard CMOS process. The

ISLA118P50 is part of a pin-compatible portfolio of 8, 10 and

12-bit A/Ds. This device an upgrade of the KAD551XP-50

product family and is pin similar.

The device utilizes two time-interleaved 250MSPS unit A/Ds to

achieve the ultimate sample rate of 500MSPS. A single 500MHz

conversion clock is presented to the converter, and all interleave

clocking is managed internally. The proprietary Intersil Interleave

Engine (I2E) performs automatic fine correction of offset, gain,

and sample time skew mismatches between the unit A/Ds to

optimize performance. No external interleaving algorithm is

required.

A serial peripheral interface (SPI) port allows for extensive

configurability of the A/D. The SPI also controls the interleave

correction circuitry, allowing the system to issue continuous

calibration commands as well as configure many dynamic

parameters.

Digital output data is presented in selectable LVDS or CMOS

formats. The ISLA118P50 is available in a 72-contact QFN

package with an exposed paddle. Performance is specified over

the full industrial temperature range (-40°C to +85°C).

Features

• 1.15GHz Analog Input Bandwidth

• 90fs Clock Jitter

• Automatic Fine Interleave Correction Calibration

• Multiple Chip Time Alignment Support via the Synchronous

Clock Divider Reset

• Programmable Gain, Offset and Skew Control

• Over-Range Indicator

• Clock Phase Selection

• Nap and Sleep Modes

• Two’s Complement, Gray Code or Binary Data Format

• DDR LVDS-Compatible or LVCMOS Outputs

• Programmable Test Patterns and Internal Temperature Sensor

Applications

• Radar and Electronic/Signal Intelligence

• Broadband Communications

• High-Performance Data Acquisition