The ISL22326WMVEP integrates two digitally controlled

potentiometers (XDCP) and non-volatile memory on a

monolithic CMOS integrated circuit.

The digitally controlled potentiometers are implemented with

a combination of resistor elements and CMOS switches. The

position of the wipers are controlled by the user through the

I

2C bus interface. Each potentiometer has an associated

volatile Wiper Register (WR) and a non-volatile Initial Value

Register (IVR) that can be directly written to and read by the

user. The contents of the WR controls the position of the

wiper. At power-up, the device recalls the contents of the two

DCP’s IVR to the corresponding WRs.

The DCPs can be used as three-terminal potentiometers or

as two-terminal variable resistors in a wide variety of

applications including control, parameter adjustments and

signal processing.

Features

• Specifications per DLA VID V62/08604-01XE

• Full Mil-Temp Electrical Performance from -55°C to +125°C

• Controlled Baseline with One Wafer Fabrication Site and

One Assembly/Test Site

• Full Homogeneous Lot Processing in Wafer Fab

• No Combination of Wafer Fabrication Lots in Assembly

• Full Traceability Through Assembly and Test by

Date/Trace Code Assignment

• Enhanced Process Change Notification

• Enhanced Obsolescence Management

• Eliminates Need for Up-Screening a COTS Component

• Two Potentiometers in One Package

• 128 Resistor Taps

• I2C Serial Interface

- Three Address Pins, Up To Eight Devices/Bus

• Non-volatile Storage of Wiper Position

• Wiper Resistance: 70Ω Typical @ 3.3V

• Shutdown Mode

• Shutdown Current 5µA Max

• Power Supply: 2.7V to 5.5V

• 10kΩ Total Resistance

• High Reliability

- Endurance: 1,000,000 Data Changes Per Bit Per

Register

- Register Data Retention:

- 10 years @ T ≤ +125°C

- 15 years @ T ≤ +90°C

- 50 years @ T ≤ +55°C

• 14 Ld TSSOP