The HIP1015 and HIP1016 are hot swap power controllers. The HIP1015 is targeted for a +12V bus whereas the HIP1016 is targeted for +5V applications. Each has an undervoltage (UV) monitoring and reporting with a threshold level ~17 lower than the nominal +12V and +5V.

Features

• HOT SWAP Single Power Distribution Control (HIP1015 for 12V, HIP1016 for 5V and Low Side Switch)

• Undervoltage Monitoring and Notification

• Overcurrent Fault Isolation

• Programmable Current Regulation Level

• Programmable Current Limit Time to Latch-Off

• Rail to Rail Common Mode Input Voltage Range (HIP1015)

• Internal Charge Pump Allows the use of N-channel MOSFET (HIP1015)

• Undervoltage and Overcurrent Latch Indicators

• Adjustable Turn-On Ramp

• Protection During Turn On

• Two Levels of Overcurrent Detection Provide Fast Response to Varying Fault Conditions

• Less Than 1µs Response Time to Dead Short

Applications

• Power Distribution Control

• Hot Plug Components and Circuitry

• High Side Low Voltage (< +15V) Switching

• Low Side High Voltage (> +15V, Negative V) Switch