Bluetooth v.3.0+EDR Dual-MIC Multimedia SOC

The IS1682S is a highly integrated ultra-low power, single-chip RF and baseband IC for Bluetooth v3.0+EDR Single/Dual-MIC applications. The IS1682S builds in an audio processor and high performance stereo codec to support the enhanced audio and speech. To provide superior audio and voice quality, it • Compliant with Bluetooth Specification v.3.0 + EDR in 2.4GHZ ISM band\n• Class 2 Bluetooth radio with +4dBm transmit power and -91dBm receiver sensitivity\n• 16-bit/32-bit run time configurable audio processor\n• HFP v1.6 includes wideband speech and mSBC codec\n• Multipoint HFP connection to 2 ph;

OPIC Light Detector for X40 Speed CD-ROM Drive

General Description Sharps IS1682 is OPIC light detectors which are used for pick-up in X40 speed CD-ROM drive. They improve noise resistance characteristics and enable to read low reflective CD-RW due to built-in RF amp. Features (1) High speed response(Response frequency: MIN. 45MHz) (Best su

Total Elapsed Time Recorder with Alarm

DESCRIPTION The DS1682 is an integrated elapsed time recorder that will provide the total amount of time that an event is/has been active since the DS1682 was last reset to zero via the 2-wire bus. When the total time accumulated is equal to the preset alarm trip point and the polarity bit is set

Total Elapsed Time Recorder with Alarm

DESCRIPTION The DS1682 is an integrated elapsed time recorder that will provide the total amount of time that an event is/has been active since the DS1682 was last reset to zero via the 2-wire bus. When the total time accumulated is equal to the preset alarm trip point and the polarity bit is set

Switched-Capacitor Voltage Doublers

General Description The ultra-small MAX1682/MAX1683 monolithic, CMOS charge-pump voltage doublers accept input voltages ranging from +2.0V to +5.5V. Their high voltage-conversion efficiency (over 98) and low operating current (110µA for MAX1682) make these devices ideal for both battery-powered a

Integrated Circuit Pre-Amplifier Circuit for Remote Control Signal Receivers

Description: The NTE1682 is an integrated circuit in a 9–Lead SIP type package designed for use in infrared and various types of remote control signal receivers. Features: • High Sensitivity, High Gain, Low Noise • Waveform Shaping Circuit • Voltage Regulator Circuit