Dual CMOS Driver/Voltage Translator

Description The IH6201 is a CMOS, Monolithic, Dual Voltage Translator; it takes low level TTL or CMOS logic signals and converts them to higher levels (i.e. to ±15V swings). This translator is typically used in making solid state switches, or analog gates. Features • Driven Direct from TTL or C

Analog Switches and Multiplexers

Analog Switches with Dviver

P-CHANNEL JFET

GENERAL INFORMATION/CROSS REFERENCES

Dual CMOS Driver/Voltage Translator

Description The IH6201 is a CMOS, Monolithic, Dual Voltage Translator; it takes low level TTL or CMOS logic signals and converts them to higher levels (i.e. to ±15V swings). This translator is typically used in making solid state switches, or analog gates. Features • Driven Direct from TTL or C

Dual CMOS Driver/Voltage Translator

Description The IH6201 is a CMOS, Monolithic, Dual Voltage Translator; it takes low level TTL or CMOS logic signals and converts them to higher levels (i.e. to ±15V swings). This translator is typically used in making solid state switches, or analog gates. Features • Driven Direct from TTL or C

Dual CMOS Driver/Voltage Translator

Description The IH6201 is a CMOS, Monolithic, Dual Voltage Translator; it takes low level TTL or CMOS logic signals and converts them to higher levels (i.e. to ±15V swings). This translator is typically used in making solid state switches, or analog gates. Features • Driven Direct from TTL or C

8-BIT MCUs WITH A/D CONVERTER, TWO TIMERS, OSCILLATOR SAFEGUARD & SAFE RESET

INTRODUCTION The ST6200C, 01C and 03C devices are low cost members of the ST62xx 8-bit HCMOS family of microcontrollers, which is targeted at low to medium complexity applications. All ST62xx devices are based on a building block approach: a common core is surrounded by a number of on-chip periph

LOW VOLTAGE 8-BIT ROM MCUs WITH A/D CONVERTER,AND 16 PINS

INTRODUCTION The ST6200C, 01C and 03C devices are low cost members of the ST62xx 8-bit HCMOS family of microcontrollers, which is targeted at low to medium complexity applications. All ST62xx devices are based on a building block approach: a common core is surrounded by a number of on-chip periph

Transmissive Optical Sensor with Schmitt Trigger Logic Output

Description This device consists of a transmissive sensor with a 3-pin connector. The operating wavelength is λ = 950 nm. The detector consists of a photologic-IC with Schmitt trigger output. Features ● Output:    ‘LOW’ when infrared beam is not interrupted ● Inverter-open collector ● TLL co

High Efficiency LED, 5 mm Tinted Non-Diffused Package

文件：130.169 Kbytes Page：9 Pages

GaAlAs Infrared Emitting Diodes in ø 5 mm (T–13/4) Package

文件：87.93 Kbytes Page：6 Pages