General Description

The HT0610 is a driver and controller LSI for graphic dot-matrix liquid crystal display systems. It has 33 common and 120 segment driver circuits. This chip is connected directly to an MCU, accepts 8-bit parallel display data and stores an on-chip graphic display data RAM (BGDRAM) of 33 x 120 bits. It provides a high-flexible display section due to the one-to-one correspondence between BGDRAM bits and LCD panel pixels. It performs BGDRAM read/write operation with no externally operating clock to minimize power consumption. In addition, because it contains power supply circuits necessary to drive an LCD, it is possible to make a display system with minimal components.

Features

• Operating voltage: 2.4V~3.5V

• 33 common/120 segment LCD driver output

• 33x120=3960 bits capacity of built-in graphic display data RAM (BGDRAM)

• Master and slave mode available for multi-chip operation

• 8-bit Parallel interface with general MCU

• On-chip oscillator circuit for display clock, external clock can also be used

• Selectable multiplex ratio: 1/16, 1/32, 1/33

• Selectable bias ratio: 1/5 or 1/7

• External driving circuit for external bias supply

• On-chip selectable voltage doublers and tripler

• Wide range of operating temperature: -30°C to 85°C

• S/W controlled electronic contrast control function (16 levels)

• External contrast control

• Low power icon mode driven by com32

• Four static icon driver circuit

• High accuracy voltage regulator with temperature coefficient (0.00, -0.18, -0.22, -0.35)

• Low power consumption

- Read/write mode 170μA (Typical)

- Display mode 160μA (Typical)

- Standby mode 15μA (Typical; Display off; internal oscillator enable)

- Standby mode < 1μA (Typical; Display off; external oscillator enable)

• CMOS process

• TCP available