Programmable Linear Hall Effect Sensor

Introduction The Hall programmer board V 5.1 is a general-purpose programming interface which is capable of addressing the programmable Micronas Hall-effect sensor families HAL 8xy and HAL 100x. The Hall programmer board V 5.1 is fully software compatible to the Hall programmer board V 4.1. Henc

Programmable Linear Hall-Effect Sensor

Introduction The HAL805 is a recent member of the Micronas family of programmable linear Hall sensors. It offers open circuit detection and individual programming of different sensors which are in parallel to the same supply voltage. Features – high-precision linear Hall effect sensor w

Programmable Linear Hall-Effect Sensor

Silicon MOS IC

Silicon MOS IC ■Features ●Output MOSFET with high breakdown voltage for voltage step-up, EL driver and CMOS control circuits are integrated into one chip. ●Oscillation circuit is incorporated ●EL voltage controlled push-pull drive system achieves higher EL light intensity. (160Vp-p

SCR?셲

Description Available either in sensitive (TS8) or standard (TN8 / TYN) gate triggering levels, the 8 A SCR series is suitable to fit all modes of control found in applications such as overvoltage crowbar protection, motor control circuits in power tools and kitchen aids, inrush current limiting

MICROWAVE LOW NOISE AMPLIFIER NPN SILICON EPITAXIAL TRANSISTOR WITH BUILT-IN 2 ELEMENTS MINI MOLD

FEATURES • Low Noise, High Gain • Operable at Low Voltage • Small Feed-back Capacitance Cre = 0.3 pF TYP. • Built-in 2 Transistors (2 × 2SC4958)

MICROWAVE LOW NOISE AMPLIFIER NPN SILICON EPITAXIAL TRANSISTOR WITH BUILT-IN 2 ELEMENTS MINI MOLD

FEATURES • Low Noise, High Gain • Operable at Low Voltage • Small Feed-back Capacitance Cre = 0.3 pF TYP. • Built-in 2 Transistors (2 × 2SC4958)

HIGH EFFICIENCY RECTIFIER (VOLTAGE RANGE 50 to 400 Volts CURRENT 8.0 Amperes)

文件：24.81 Kbytes Page：2 Pages