■ DESCRIPTION

The MB90595/595G series with FULL-CAN*1 interface and FLASH ROM is especially designed for automotive and industrial applications. Its main features are two on board CAN Interfaces, which conform to V2.0 Part A and Part B, while supporting a very flexible message buffer scheme and so offering more functions than a normal full CAN approach.

■ FEATURES

• Clock

Embedded PLL clock multiplication circuit

Operating clock (PLL clock) can be selected from divided-by-2 of oscillation or one to four times the oscillation (at oscillation of 4 MHz, 4 MHz to 16 MHz).

Minimum instruction execution time: 62.5 ns (operation at oscillation of 4 MHz, four times the oscillation clock, VCC of 5.0 V)

• Instruction set to optimize controller applications

Rich data types (bit, byte, word, long word)

Rich addressing mode (23 types)

Enhanced signed multiplication/division instruction and RETI instruction functions

Enhanced precision calculation realized by the 32-bit accumulator

• Instruction set designed for high level language (C language) and multi-task operations

Adoption of system stack pointer

Enhanced pointer indirect instructions

Barrel shift instructions

• Program patch function (for two address pointers)

• Enhanced execution speed: 4-byte instruction queue

• Enhanced interrupt function: 8 levels, 34 factors

• Automatic data transmission function independent of CPU operation

Extended intelligent I/O service function (EI2OS): Up to 10 channels

• Embedded ROM size and types

Mask ROM: 128 Kbytes

Flash ROM: 128 Kbytes

Embedded RAM size: 4 Kbytes (MB90V595/595G: 6 Kbytes)

• Flash ROM

Supports automatic programming, Embedded Algorithm TM*

Write/Erase/Erase-Suspend/Resume commands

A flag indicating completion of the algorithm

Hard-wired reset vector available in order to point to a fixed boot sector

Erase can be performed on each block

Block protection with external programming voltage

• Low-power consumption (stand-by) mode

Sleep mode (mode in which CPU operating clock is stopped)

Stop mode (mode in which oscillation is stopped)

CPU intermittent operation mode

Hardware stand-by mode

• Process: 0.5 µm CMOS technology

• I/O port

General-purpose I/O ports: 78 ports

Push-pull output and Schmitt trigger input.

Programmable on each bit as I/O or signal for peripherals.

• Timer

Watchdog timer: 1 channel

8/16-bit PPG timer: 8/16-bit × 6 channels

16-bit re-load timer: 2 channels

• 16-bit I/O timer

Input capture: 4 channels

Output compare: 4 channels

• Extended I/O serial interface: 1 channel

• UART0

With full-duplex double buffer (8-bit length)

Clock asynchronized or clock synchronized (with start/stop bit) transmission can be selectively used.

• UART1 (SCI)

With full-duplex double buffer (8-bit length)

Clock asynchronized or clock synchronized serial transmission (I/O extended transmission) can be selectively used.

• Stepping motor controller (4 channels)

• External interrupt circuit (8 channels)

A module for starting an extended intelligent I/O service (EI2OS) and generating an external interrupt which is triggered by an external input.

• Delayed interrupt generation module: Generates an interrupt request for switching tasks.

• 8/10-bit A/D converter (8 channels)

8/10-bit resolution can be selectively used.

Starting by an external trigger input.

• FULL-CAN interface: 1 channel

Conforming to Version 2.0 Part A and Part B

Flexible message buffering (mailbox and FIFO buffering can be mixed)

• 18-bit Time-base counter

• External bus interface: Maximum address space 16 Mbytes