8-Bit HCS08 Central Processor Unit (CPU)

• Up to 40 MHz HCS08 CPU (central processor unit); up to 20 MHz bus frequency

• HC08 instruction set with added BGND instruction

On-Chip Memory

• 4 KB of FLASH with read/program/erase over full operating voltage and temperature

• 256 bytes of Random-access memory (RAM)

Power-Saving Modes

• Two very low power stop modes

• Reduced power wait mode

Clock Source Options

• Oscillator (XOSC) — Loop-control Pierce oscillator; Crystal or ceramic resonator range of 32 kHz to 38.4 kHz or 1 MHz to 16 MHz

• Internal Clock Source (ICS) — Internal clock source module containing a frequency-locked loop (FLL) controlled by internal or external reference; precision trimming of internal reference allows 0.2 resolution and 2.0 deviation over temperature and voltage; supports bus frequencies from 2 MHz to 20 MHz.

System Protection

• Watchdog computer operating properly (COP) reset with option to run from dedicated 1 kHz internal clock source or bus clock

• Low-voltage detection with reset or interrupt; selectable trip points

• Illegal opcode detection with reset

• Illegal address detection with reset

• FLASH block protect

• Reset on loss of clock

Development Support

• Single-wire background debug interface

• Breakpoint capability to allow single breakpoint setting during in-circuit debugging

Peripherals

• SCI — Serial Communication Interface

— Full-duplex non-return to zero (NRZ)

— LIN master extended break generation

— LIN slave extended break detection

— Wake-up on active edge

• TPMx — Two 2-channel Timer/PWM modules (TPM1 and TPM2)

— 16-bit modulus or up/down counters

— Input capture, output compare, buffered edge-aligned or center-aligned PWM

• ADC — Analog to Digital Converter

— 8-channel, 10-bit resolution

— 2.5 μs conversion time

— Automatic compare function

— Temperature sensor

— Internal bandgap reference channel

Input/Output

• 12 general purpose I/O pins (GPIOs)

• 8 interrupt pins with selectable polarity

• Hysteresis and configurable pull-up device on all input pins; Configurable slew rate and drive strength on all output pins.

Package Options

• 16-TSSOP

Operating Parameters

• 4.5-5.5 V operation

• C,V, M temperature ranges available, covering -40 - 125 °C operation