Incorporating Clock Generator Output and FTDIChip-ID Security Dongle

Features Hardware Features • Single chip USB to asynchronous serial data transfer interface. • Entire USB protocol handled on the chip - No USB-specific firmware programming required. • UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity. •

FT232RQ - 接口桥接器, USB 到 UART, 1.8 V, 5.25 V, QFN, 32 引脚, -40 °C

·单芯片USB至异步串行数据传输接口\n·片上处理所有USB协议. 不需USB特别固件编程.\n·全集成的1024位EEPROM存储设备描述符和CBUS输入/输出配置\n·全集成USB终端电阻\n·全集成时钟生成, 不需外部晶体\n·数据传送率从300波特至3M波特(RS422, RS485, RS232 ), TTL电平\n·128字节接受缓冲和256字节发送缓冲\n·FTDI免版税的虚拟Com端口和直接驱动器消减了USB驱动器开发的需要\n·独特USB FTDI芯片识别功能\n·可配置CBUS输入/输出引脚;

Future Technology Devices International Ltd.

文件：776.22 Kbytes Page：43 Pages

Single chip USB to asynchronous serial data transfer interface

文件：1.20141 Mbytes Page：40 Pages

Bit Bang Modes for the FT232R and FT245R

文件：254.12 Kbytes Page：13 Pages

USB UART IC - Single chip USB to asynchronous serial data transfer interface

文件：774.47 Kbytes Page：43 Pages

Single chip USB to asynchronous serial data transfer interface

文件：1.20141 Mbytes Page：40 Pages

封装/外壳：32-VFQFN 裸露焊盘 功能：桥，USB 至 UART 包装：管件 描述：IC USB FS SERIAL UART 32-QFN 集成电路（IC） 控制器

Future Technology Devices International Ltd.

文件：776.22 Kbytes Page：43 Pages

封装/外壳：32-VFQFN 裸露焊盘 功能：桥，USB 至 UART 包装：托盘 描述：IC USB FS SERIAL UART 32QFN 集成电路（IC） 控制器

Single chip USB to asynchronous serial data transfer interface

文件：1.20141 Mbytes Page：40 Pages

VERY HIGHSPEED, ULTRA LOWPOWERCONSUMPTION 5V POWERED RS-232 DRIVERS AND RECEIVERS

Description The ST232A is a 2 driver, 2 receiver device following EIA/TIA-232 and V.28 communication standard. It is particularly suitable for applications where ±12V is not available. The ST232A uses a single 5V power supply and only four external capacitors (0.1µF). Typical applications are i

5V POWERED MULTI-CHANNEL RS-232 DRIVERS AND RECEIVERS

DESCRIPTION The ST232 is a 2 driver, 2 receiver device following EIA/TIA-232 and V.28 communication standard. It is particularly suitable for applications where ±12V is not available. The ST232 uses a single 5V power supply and only four external capacitors (0.1µF). Typical applications are in:

5V POWERED MULTI-CHANNEL RS-232 DRIVERS AND RECEIVERS

DESCRIPTION The ST232 is a 2 driver, 2 receiver device following EIA/TIA-232 and V.28 communication standard. It is particularly suitable for applications where ±12V is not available. The ST232 uses a single 5V power supply and only four external capacitors (0.1µF). Typical applications are in:

5V POWERED MULTI-CHANNEL RS-232 DRIVERS AND RECEIVERS

DESCRIPTION The ST232 is a 2 driver, 2 receiver device following EIA/TIA-232 and V.28 communication standard. It is particularly suitable for applications where ±12V is not available. The ST232 uses a single 5V power supply and only four external capacitors (0.1µF). Typical applications are in:

5V POWERED MULTI-CHANNEL RS-232 DRIVERS AND RECEIVERS

DESCRIPTION The ST232 is a 2 driver, 2 receiver device following EIA/TIA-232 and V.28 communication standard. It is particularly suitable for applications where ±12V is not available. The ST232 uses a single 5V power supply and only four external capacitors (0.1µF). Typical applications are in: