1.36W单声道 全差动架构的音频放大器

EUA6204是一款单声道的全差动架构音频放大器，当电源电压为5V时，连续传递1.36W平均功率至8Ω BTL负载，并使失真度(THD+N) 控制在1%以下，当电源电压为3.6V时，传递720mW至8Ω负载。 •工作电压2.5 V到5.5 V\n•THD=1%時, 5V电源供应能传递1.36W功率至8Ω BTL负载\n•低静态电流︰5 V時（典型4mA）\n•非常低的关断电流(典型0.01uA)\n•微小Pop可快速重新开机\n•3 个外部组成组件\n- 高PSRR(-80dB)可采用直流电池供电\n- 全差动设计减少RF修正\n- 高CMRR(-63dB) 无需输入耦合电容\n•符合RoHS规范及Pb-Free;

1.36-W Mono Fully Differential Audio Power Amplifier

文件：379.48 Kbytes Page：12 Pages

3W 单声道全差动架构的音频放大器

EUA6204A是一款单声道的全差动架构音频放大器，，当电源电压为5V时，能连续传递3W平均功率至3Ω BTL负载，并使失真度(THD+N)控制在10%以下。当电源电压为3.6V时，能传递720mW至8Ω负载。 •工作电压2.5 V到5.5 V\n•当电源电压为5V\n- THD=1%時,能传递2.3W功率至3Ω 负载\n- THD=10%時, 能传递3W功率至3Ω 负载\n•低静态电流︰5 V時（典型4mA）\n•非常低的关断电流(典型0.01uA)\n•微小Pop可快速重新开机\n•3 个外部组成组件\n- 高PSRR(-80dB)可采用直流电池供电\n- 全差动设计减少RF调整\n- 高CMRR(-63dB)无需输入耦合电容器\n•符合RoHS规范及Pb-Free;

1.36W 单声道全差分音频功率放大器

EUA6204C 是单声道全差分音频功放，它在5V 电源，8Ω 负载输出功率1.36W 时失真小于1%，在3.6V 电源，8Ω 负载输出功率可达720mW 。\nEUA6204C是掌上电脑、智能手机等应用的理想选择，在20Hz 到20kHz 的音频范围内，电源电压抑制比达到-80dB，具有良好的RF 整流抗扰度，在PCB 上仅占用20mm2 的面积，且快速启动没有POP 声。\nEUA6204C 可以使用MSOP-8 封装、同时支持节省空间的3mm×3mm DFN-8 封装。 •应用电压 2.5V ~ 5.5V\n•低电源电流: 5V 供电耗电4mA\n•快速启动且没有上电 POP 声\n•共模抑制比达-63dB，可以节省两个输入耦合电容\n•符合 RoHS 标准，100％无铅（Pb）;

3W Mono Fully Differential Audio Power Amplifier

文件：384.03 Kbytes Page：11 Pages

3W Mono Fully Differential Audio Power Amplifier

文件：384.03 Kbytes Page：11 Pages

1.36-W Mono Fully Differential Audio Power Amplifier

文件：379.48 Kbytes Page：12 Pages

1.36-W Mono Fully Differential Audio Power Amplifier

文件：379.48 Kbytes Page：12 Pages

Laser Driver Oscillator

General Description The EL6204C is a push-pull oscillator used to reduce laser noise. It uses the standard interface to existing ROM controllers. The frequency and amplitude are each set with a separate resistor connected to ground. The tiny package and harmonic reduction allow the part to be pla

Laser Driver Oscillator

General Description The EL6204C is a push-pull oscillator used to reduce laser noise. It uses the standard interface to existing ROM controllers. The frequency and amplitude are each set with a separate resistor connected to ground. The tiny package and harmonic reduction allow the part to be pla

DMOS DUAL FULL BRIDGE DRIVER

DESCRIPTION The L6204 is a dual full bridge driver for motor control applications realized in BCD technology which combines isolated DMOS power transistors with CMOS and Bipolar circuits on the same chip. By using mixed technology it has been possible to optimize the logic circuitry and the power

PIN DIODE

DESCRIPTION These series of PIN diodes are designed for applications requiring small package size and moderate average power handling capability. The low capacitance of the UM6000 and UM6600 allows them to be used as series switching elements to 1 GHz. The low resistance of the UM6200 is useful

Voltage Regulators

文件：25.85 Kbytes Page：1 Pages