Programmable Current-Limited Load Switch

The ETA6280 is a load switch which provides full protection to systems and loads which may encounter large current conditions. ETA6280 offers a 70mΩ current-limited switch which can operate over an input voltage range of 2.1-6V. The current limit can be externally programmed by a precision resistor, • Wide Input Voltage Range: 2.1V to 6V\n\n• 5V Input Standoff Voltage\n\n• 1V OVP\n\n• Up to 2A Max Continuous Load Current\n\n• Programmable Current Limit: 75mA to 2200mA\n\n• Fast Over Current Response\n\n• Fault Flag Output: nFAULT Pin\n\n• Reversed Input-Output Current Blocking\n\n• Thermal Shut;

Dual Laser Driver with APC Amp

General Description The EL6280C is a combination read + 3 write level laser driver and IV amplifier, with an extra read + oscillator ROM channel for use in dual-laser ‘Combo’ drivers. A separate (amplitude and frequency) oscillator modulates the selected output for laser noise reduction during re

THREE CHANNELS MULTIPOWER DRIVER SYSTEM

DESCRIPTION The L6280 is a multipower driver system for motor and solenoid control applicatios that connects directly to a microprocessor bus. Realized in Multipower BCD technology -- which combines isolated DMOS transistors, CMOS & bipolar circuits on the same chip -- it integrates two 1A mo

DOUBLE HETEROJUNCTION SUNLIGHT VIEWABLE DISPLAYS

DOUBLE HETEROJUNCTION AIGaAs RED SUNLIGHT VIEWABLE DISPLAYS

REAL TIME EMULATION DEVELOPMENT TOOLS FOR ST6 MCU FAMILY

GENERAL DESCRIPTION The ST6 Real Time Development System is an advanced hardware development system designed and configured to provide comprehensive support for the ST6 family of MCUs. HARDWARE FEATURES ■ Supports ST62 and ST63 family ■ Real time emulation ■ 32 KBytes of emulation memory ■ B

DOUBLE HETEROJUNCTION AIGAAS RED SUNLIGHT VIEWABLE DISPLAYS

文件：405.92 Kbytes Page：5 Pages