2CH 6A Load Switch with Slew Rate Control

The ET3176 is a dual-channel load switch with controlled turn on. The device contains two N-channel MOSFETs that can operate over an input voltage range of 0.6V to 5.7V and can support a maximum continuous current of 6A per channel. Each switch is independently controlled by an on and off input (ON1 • Integrated Dual- Channel Load Switch\n\n• VBIASVoltage Range:2.5V to 5.7V\n\n• Input Voltage Range: 0.6V to VBIAS\n\n• Ultra low RONResistance :\n-- RON=18mΩ(Typical) at VIN=0.6V to 5V ,VBIAS=5V\n-- RON=22mΩ(Typical) at VIN=0.6V to 2.5V, VBIAS=2.5V\n\n• 6A Maximum Continuous Switch Current per cha;

IF Amplifier for FM Receiver (AFC Supported)

High-speed paging systems that employ M-ary signals are about to enter service. Sony strongly supports this new service with three IF ICs: the CXA3117N, the CXA3176N, and the CXA3179N. The CXA3117N, which adopts a comparator system that does not require an A/D converter, and the CXA3179N, which

Achieving Low Power and High Speed in Paging System IF IC

High-speed paging systems that employ M-ary signals are about to enter service. Sony strongly supports this new service with three IF ICs: the CXA3117N, the CXA3176N, and the CXA3179N. The CXA3117N, which adopts a comparator system that does not require an A/D converter, and the CXA3179N, which

짹15kV ESD Protected, 3.3V, Full Fail-safe, Low Power, High Speed or Slew Rate Limited, RS-485/RS-422 Transceivers

±15kV ESD Protected, 3.3V, Full Fail-Safe, Low Power, High Speed or Slew Rate Limited, RS-485/RS-422 Transceivers The Intersil ISL317XE are ±15kV IEC61000 ESD Protected, 3.3V-powered, single transceivers that meet both the RS-485 and RS-422 standards for balanced communication. These devices have

짹15kV ESD Protected, 3.3V, Full Fail-safe, Low Power, High Speed or Slew Rate Limited, RS-485/RS-422 Transceivers

±15kV ESD Protected, 3.3V, Full Fail-Safe, Low Power, High Speed or Slew Rate Limited, RS-485/RS-422 Transceivers The Intersil ISL317XE are ±15kV IEC61000 ESD Protected, 3.3V-powered, single transceivers that meet both the RS-485 and RS-422 standards for balanced communication. These devices have

Full Bridge Power Amplifier

文件：389.68 Kbytes Page：5 Pages