Glow Plug Control IC

The E525.06 is a control IC for up to 4 high-side power-NMOS typically driving glow plugs in Diesel engines. The load current is varied by PWM duty cycle modulation at the power- NMOS gates according to the requirements determined by an engine management unit.\nAdvanced control and diagnosis feature ·4 gate drivers for external hi-side power-NMOS\n·PWM controlled gate output with integrated charge pump\n·Adjustable gate charge / discharge currents\n·Gate sequencing for minimum current ripple\n·MOS protection by gate-source voltage limitation\n·Glow plug current sense with over-current shut-off\;

High Precision Cutters

Description: The 5250 is a high precision cutter belonging to the oblique head cutter family. The angled blade geometry supports the operator's ergonomics during the cut. The full-flush cutting edge is suitable to perform very clean cuts on small size material. The 5250 is equipped with an ESD Erg

High Precision Cutters

Description: The 5250 is a high precision cutter belonging to the oblique head cutter family. The angled blade geometry supports the operator's ergonomics during the cut. The full-flush cutting edge is suitable to perform very clean cuts on small size material. The 5250 is equipped with an ESD Erg

Configured Digitally Programmable Potentiometer (DPP??: Programmable Voltage Applications

DESCRIPTION The CAT525 is a quad 8-bit digitally programmable potentiometer (DPP™) configured for programmable voltage and DAC-like applications. Intended for final calibration of products such as camcorders, fax machines and cellular telephones on automated high volume production lines and syste

Surface Mount High Performance AlInGaP LED Indicators

Description The LED material used in these devices is the very efficient absorbing Substrate aluminum indium gallium phosphide (AS AlInGaP), capable of producing high light output over a wide range of drive currents. Features • Outstanding LED Material Efficiency • Exceptional Light Output Ove

SINGLE CELL BATTERY POWERED ELECTROLUMINESCENT LAMP DRIVER/INVERTER

The IMP525 is an Electroluminescent (EL) lamp driver designed for systems that must operate below 1 volt. The input supply voltage range is 0.9V to 2.5V. Typical output lamp drive voltage is 112V. All four EL lampdriving functions are on-chip. These are the switch-mode power supply, its high-frequ

SINGLE CELL BATTERY POWERED ELECTROLUMINESCENT LAMP DRIVER/INVERTER

The IMP525 is an Electroluminescent (EL) lamp driver designed for systems that must operate below 1 volt. The input supply voltage range is 0.9V to 2.5V. Typical output lamp drive voltage is 112V. All four EL lampdriving functions are on-chip. These are the switch-mode power supply, its high-frequ

Silicon Diode High Voltage Fast Recovery Switch

Features: ● Fast Switching ● Low Leakage ● High Current Capability ● High Surge Capability ● High Reliability