36V Max. H-bridge Drivers

ROHM的Ｈ电桥驱动器系列通过不同电源电压 (耐压7V/18V/36V) 与不同输出电流 (Iomax 0.5A/1A/2A) 的组合而形成品种齐全的多个型号产品，适用于各种用途。优化了以往产品中VREF可变功能，在原来应用方式下方便地实现了低功耗化和高效率化。而且，由于内置有充足的保护电路，如温度保护电路 (TSD)、过流保护电路 (OCP)、过压保护电路 (OVP)、防欠压误操作电路 (UVLO) 等，所以在各种不同条件下都可以保护驱动器IC和负载，使整机具有高可靠性。 •低待机电流\n•可以输入PWM控制信号 (20k～100kHz)\n•利用VREF电压设定引脚控制PWM占空比\n•内置有防直通电流电路\n•输出保护电路 (过流/过压/过热/欠压);

DC Brush Motor Drivers (36V max.)

文件：662.74 Kbytes Page：25 Pages

DC Brush Motor Drivers

Overview These H-bridge drivers are full bridge drivers for brush motor applications. Each IC can operate at a wide range of power supply voltages (from 3V to 36V), supporting output currents of up to 2A. MOS transistors in the output stage allow for PWM signal control, while the integrated VREF

DC Brush Motor Drivers (36V max.)

文件：662.74 Kbytes Page：25 Pages

封装/外壳：28-SOP（0.295"，7.50mm 宽）+ 2 热凸片 功能：驱动器 - 全集成，控制和功率级 包装：管件 描述：IC MOTOR DRIVER 6V-32V 28HSOP 集成电路（IC） 电机驱动器，控制器

H-bridge drivers (36V max.)

文件：389.87 Kbytes Page：17 Pages

High-Efficiency, Quad-Output, Main Power Supply Controllers for Notebook Computers

The ISL6237 dual step-down, switch-mode power-supply (SMPS) controller generates logic-supply voltages in battery-powered systems. The ISL6237 includes two pulse-width modulation (PWM) controllers, 5V/3.3V and 1.5V/1.05V. The output of SMPS1 can also be adjusted from 0.7V to 5.5V. The SMPS2 output

High-Efficiency, Quad-Output, Main Power Supply Controllers for Notebook Computers

The ISL6237 dual step-down, switch-mode power-supply (SMPS) controller generates logic-supply voltages in battery-powered systems. The ISL6237 includes two pulse-width modulation (PWM) controllers, 5V/3.3V and 1.5V/1.05V. The output of SMPS1 can also be adjusted from 0.7V to 5.5V. The SMPS2 output

IR Receiver Modules for Remote Control Systems

DESCRIPTION The TSOP6... series are miniaturized SMD IR receiver modules for infrared remote control systems. A PIN diode and a preamplifier are assembled on a leadframe, the epoxy package contains an IR filter. The demodulated output signal can be directly connected to a microprocessor for deco

IR Receiver Modules for Remote Control Systems

文件：417.9 Kbytes Page：13 Pages