Description

USS-820FD is a USB device controller that provides a programmable bridge between the USB and a local microprocessor bus. It is available in a 48-ball TFSBGAC package. The USS-820FD allows PC peripherals to upgrade to USB connectivity without major redesign effort. It is programmable through a simple read/write register interface that is compatible with industry-standard USB microcontrollers.

Features

■ Full compliance with the Universal Serial Bus Specification Revision 1.1.

■ Backward compatible with USS-820B, USS-820C, and USS-820D revisions.

■ Self-powered or bus-powered USB device. Meets USB power specifications for bus-powered devices.

■ Full-speed USB device (12 Mbits/s).

■ USB device controller with protocol control and administration for up to 16 USB endpoints.

■ Supports control, interrupt, bulk, and isochronous transfers for all 16 endpoints.

■ Programmable endpoint types, FIFO sizes, and internal 1120-byte logical (2240-byte physical for dual-packet mode) shared FIFO storage allow a wide variety of configurations.

■ Dual-packet mode of FIFOs reduces latency.

■ Supports USB remote wake-up feature.

■ On-chip crystal oscillator allows external 12 MHz crystal or 3 V/5 V clock source.

■ On-chip analog PLL creates 48 MHz clock from internal 12 MHz clock.

■ Integrated USB transceivers.

■ 5 V tolerant I/O buffers allow operation in 3 V or 5 V system environments for 0 °C to 70 °C temperature range.

■ 5 V tolerant I/O buffers allow operation in 3 V only system environments for –20 °C to +85 °C temperature range.

■ Implemented in Agere Systems Inc. 0.25 µm, 3 V standard-cell library.

■ 48-ball TFSBGAC. (Lead-free package also available. (See Ordering Information on page 51.)

■ Evaluation kit available.

New Features After Revision B

■ New, centralized FIFO status bits and interrupt output pin reduce firmware load.

■ New, additional nonisochronous transmit mode allows NAK response to cause interrupt.

■ Isochronous behavior enhancements simplify firmware control.

■ Additional FIFO sizes for nonisochronous endpoints.

■ USB reset can be programmed to clear device address.

■ USB reset output status pin.

■ Firmware ability to wake up and reset a suspended device.

■ Lower power.

■ 5 V supply no longer required for 5 V tolerant operation.

Applications

■ Suitable for peripherals with embedded microprocessors.

■ Glueless interface to microprocessor buses.

■ Support of multifunction USB implementations, such as printer/scanner and integrated multimedia applications.

■ Suitable for a broad range of device class peripherals in the USB standard.